Product Data Sheet

WF AC-603

PRODUCT DESCRIPTION • A separation layer of polyethylene, kraft paper or similar

should be placed on the STARPROOF WF-AC-603
membrane before topping with sand, cement screed or
STARPROOF WF AC-603 is a blend of special acrylic tiles of 4 to 5 cm thickness.
polymer resins and additives. It provides a seamless,
TECHNICAL SPECIFICATION
durable, elastomeric and vapor permeable membrane. It has
excellent UV resistance
Color White & Grey

APPLICATION Solid Content, %

60 - 67
• It is used for concrete roofs, polyester built up roofs, (ASTM-D 1076)
masonry and concrete walls. Viscosity, Cps 30,000 – 50,000
• It can also be used for other applications such as @25ºC, S 6, rpm 20
reflective and protective waterproof coating to concrete, Specific Gravity, g/ml
asphalt and bitumen, asbestos, cement, slates and tiles, 1.30 – 1.50
(ASTM 1475-16)
zinc, timber surfaces, etc.
Hardness Shore A
32 - 40
(ASTM-D 2240)
ADVANTAGES Minimum +5
Application Temp., °C
• Absolutely waterproof
• Seamless, tough and flexible finish Elongation Break, %
819
• High solar reflectivity & UV protection (@ 25°C ) (ASTM –D 412)
• Suitable for variety of roof substrates Tensile Strength, N/mm2
1.83
• Water vapor permeable (ASTM –D 412)
Water vapor transmission,
0.22
g/hr/m² (ASTM E- 96)
DIRECTIONS FOR USE Service Temperature, °C
Surface Preparation: -5 to +100
(ASTM-491)
• It may be applied by brush, roller, squeegee or spray 1
equipment. The actual method of application is selected Coverage, kg/m2
(for 0.5 mm dry film
depending on construction and project conditions. To (ASTM C 4075)
thickness)
spray, select a nozzle size of at least 0.028 inch, first
10,000
check the spray equipment to ensure suitability UV Resistance, hrs.
(No deterioration or color
• All surfaces to be coated must be clean, dry and free (ASTM D 822)
fade)
from dust, dirt, oil, grease and other contaminants
• Apply in separate coats, each at right angle to the one Non-flammable
Flash point
before using a different color
• Each coat helps to ensure consistency of cover Brushes, tools and other
• After surface preparation, apply single primer coat of equipment should be
STARPROOF WF AC-603 by brush, roller or spray Cleaning cleaned with water while
wet.
Waterproofing & Protection:
• Wait until primer gets dry, before commencing work
• Build up the required membrane thickness by applying WEATHER CONDITIONS
multiple coats of STARPROOF WF AC-603.
• Where substantial movements are anticipated in the Actual drying time depends on weather conditions and may
substructure, reinforce the STARPROOF WF AC-603 vary from one hour to full day. Do not start the work if rain is
by incorporating mesh reinforcement as part of a forecasted for subsequent 24 hours.
sandwich membrane system. Lay this mesh in the wet
coat first, before application of subsequent coats.
STORAGE
• Minimum 12 months in unopened container
• Store in dry place, keep away from direct sunlight and
at temperature above 5°C and below 30°C

Accessible Roofs:
UAE KSA INDIA
Tel. +971 6 5611411 Tel. +996 12 677 7073 Tel. +91 260 2220241
[email protected] [email protected] [email protected]
www.star-uae.com www.star-uae.com www.star-uae.com