Scribd
Upload
203 views1 page

Tds-Antifoam Ew Defoamer Saw 2510

This technical data sheet provides information about an antifoam emulsion called EW Defoamer SAW-2510. It is a non-ionic emulsion of fatty acid esters and surfactants that appears as a white, water-based emulsion. It is effective at controlling foam in systems operating between 30 to 55°C without affecting paper strength or sizing. It assists in keeping paper machines clean and does not contribute to pitch accumulation.

Uploaded by

kokotampan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
203 views1 page

Tds-Antifoam Ew Defoamer Saw 2510

This technical data sheet provides information about an antifoam emulsion called EW Defoamer SAW-2510. It is a non-ionic emulsion of fatty acid esters and surfactants that appears as a white, water-based emulsion. It is effective at controlling foam in systems operating between 30 to 55°C without affecting paper strength or sizing. It assists in keeping paper machines clean and does not contribute to pitch accumulation.

Uploaded by

kokotampan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TECHNICAL DATA SHEET

ANTIFOAM

EW DEFOAMER SAW-2510
CHEMICAL TYPE:

EMULSION OF FATTY ACID ESTERS AND


SURFACTANTS.

IONIC CHARGE: NON IONIC

PHYSICAL SPESIFICATION
1. APPEARANCE ANTIFOAM EW Defoamer SAW-2510 is a very
effective non-silicone defoamer for systems
White - Water Based Emulsion operating at temperatures of between 30 to 55°C. It
2. EMULSION PARTICLE SIZE is very persistent, therefore one addition point
normally gives good foam control throughout the
90 % Less than 15 Microns
system. It assists in the clean running of the paper
3. WATER MISCIBILITY machine since it helps disperse soil flotation, and it
does not contribute to pitch accumulation.
Good dispersion ANTIFOAM EW Defoamer SAW-2510 does not
4. FLUIDITY effect sizing or paper strength when used at normal
addition levels. ANTIFOAM EW Defoamer SAW-
Thick Liquid with adjustable viscosity
2510 being a fluid water based emulsion is easy to
during application use, biodegradable thus has a low toxicity making
it suitable for biological waste water treatment
5. CLEANLINESS application.
No Particles after screening through a 400
APPLICATION:
micron aperture screen
ANTIFOAM EW Defoamer SAW-2510 is usually
added via an air pump. The optimum quantity and
points of addition are determined by trial.
Recommended to be dissolved as much as 50%
solutions before use.

- Waste Water Treatment


10-100 ppm dosage by trial
- Paper Prodution
Typically 100 to 300 ml per tone of paper, added
to the wire pit, usually works very well.

STORAGE:
The above information is given in a good faith but without Treat like a normal water based emulsion, avoid
warranty. We can not accept liability for any damage, loss or
patent infringement resulting from the use of this information
freezing and keep container closed when not in use.

STABILITY:
12 months minimum when stored at normal
temperature

PACKAGING: 125 kgs plastic drums

You might also like