How To Upgrade or Install IOS From Trivial File Transfer Protocol (TFTP) Ser
How To Upgrade or Install IOS From Trivial File Transfer Protocol (TFTP) Ser
Home
Knowledge Base Cisco Certified Network Associate (CCNA) How to upgrade or install IOS from Trivial File
How to upgrade or install IOS from Trivial File Transfer Protocol (TFTP) Server
0Share To upgrade or install an IOS from a Trivial File Transfer Protocol (TFTP) server , you must have a TFTP Server running with the suitable IOS file in root folder of the TFTP Server. Click the following links if you are not familiar with Trivial File Transfer Protocol (TFTP). What is Trivial File Transfer Protocol (TFTP) How to install Solarwinds Trivial File Transfer Protocol (TFTP) Server How to configure Solarwinds Trivial File Transfer Protocol (TFTP) Server to
backup IOS and configuration files
Make sure that you can reach the TFTP server by pinging to it. To install IOS from TFTP server, follow these steps . 1) If you want a fresh install, erase the contents of the flash memory using the "erase" command as shown below. OmniSecuRouter01#erase flash Erasing the flash filesystem will remove all files! Continue? [confirm]y Erasing device... eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee <outout omitted> eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee ...erasedee Erase of flash: complete 2) Copy an IOS file from TFTP Server to flash memory. Make sure that you have the IOS file available in the root of the TFTP Server. To copy an IOS file from TFTP Server to the flash memory, use the following command from privileged mode. OmniSecuRouter01#copy tftp flash Address or name of remote host [192.168.100.10]? Source filename [C2600-Adventerprisek9-Mz_124-2_T.bin]? Destination filename [C2600-Adventerprisek9-Mz_124-2_T.bin]? Accessing tftp://192.168.100.10/C2600-Adventerprisek9-Mz_1242_T.bin... Erase flash: before copying? [confirm]y Erasing the flash filesystem will remove all files! Continue? [confirm]y Erasing device... eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee <output omitted> eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee...erased Erase of flash: complete Loading C2600-Adventerprisek9-Mz_124-2_T.bin from 192.168.100.10 (via FastEthernet0/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! <output omitted> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! [OK - 29771296 bytes] Verifying checksum... OK (0xECA5) 29771296 bytes copied in 376.332 secs (79109 bytes/sec)
http://www.omnisecu.com/cisco-certified-network-associate-ccna/how-to-upgrade-or-install-ios-from-tftp-server.htm[30/05/2011 16:02:35]
How to upgrade or install IOS from Trivial File Transfer Protocol (TFTP) Server
OmniSecuRouter01# After the IOS image file is copied to flash, you must reboot your router in order for it to use the new image . There are two ways you can reboot your router. Power if off and then power it on (Hard reboot) Run the reload IOS command from privilege mode (Soft reboot)
Disclaimer Feed Back Trademarks Knowledge Base FAQ Sitemap Downloads Copyright 2010 OmniSecu.com... Free Networking Tutorials, Free System Administration Tutorials and Free Security Tutorials
http://www.omnisecu.com/cisco-certified-network-associate-ccna/how-to-upgrade-or-install-ios-from-tftp-server.htm[30/05/2011 16:02:35]