Scribd
Upload
431 views

Part Approval - Initial Sample Inspection Report (ISIR)

An initial sample inspection report was completed for a pin spacer tube part from a supplier. The report details the part number, design revision level, supplier name and number, and the inspection facility used. Measurements were taken for multiple pieces of the part based on the product specifications, but the report does not include the specific measurement results. Representatives from both the supplier and John Deere signed off on the inspection results.

Uploaded by

Attam Odnamra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
431 views

Part Approval - Initial Sample Inspection Report (ISIR)

An initial sample inspection report was completed for a pin spacer tube part from a supplier. The report details the part number, design revision level, supplier name and number, and the inspection facility used. Measurements were taken for multiple pieces of the part based on the product specifications, but the report does not include the specific measurement results. Representatives from both the supplier and John Deere signed off on the inspection results.

Uploaded by

Attam Odnamra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Part Approval - Initial Sample Inspection Report (ISIR)

revision: 11 Nov 2009

Part Number: Design / Revision Level:

Part Name/Description PIN SPACER TUBE Decision Number:

Supplier Name: Supplier Number:


NACIONAL DE MAQUINADOS Y EQU Y P101402
Name of Inspection Facility: NACIONAL DE MAQUINADOS Y EQU Lab Report Attahced: e
How Many Pieces Measured: 2 s5

Nominal Dimension / Tolerance Measurement Results OK


Unit of
Item Specification & Material John Deere Verification
Measure (+) / (-) Piece 1 Piece 2 Piece 3 Piece 4 Piece 5 Not OK
Specifications

1 mm

2 mm

3 mm

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

SQM Product / Process Approval Form; revision date: 11 Nov 2009 (Sheet Protected: Code = 1234) Page 1 of 2 Printed: 07/08/2022
Nominal Dimension / Tolerance Measurement Results OK
Unit of
Item Specification & Material John Deere Verification
Measure (+) / (-) Piece 1 Piece 2 Piece 3 Piece 4 Piece 5 Not OK
Specifications

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

Supplier Representative Signature: Title: Email: Date:

John Deere Quality Representative: Title: Email: Date:

Disposition:
Approv Resubm
Fail Deviate
e it

SQM Product / Process Approval Form; revision date: 11 Nov 2009 (Sheet Protected: Code = 1234) Page 2 of 2 Printed: 07/08/2022

You might also like