Scribd
Upload
34 views

Protection of Solid State Relay Circuits... Fuse Selection

Uploaded by

Gustavo Pérez
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Protection of Solid State Relay Circuits... Fuse Selection

Uploaded by

Gustavo Pérez
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

R007

V3.0
ZELIO RELAY

Protection of Solid State Relay Circuits :


Fuse Selection

I- Type of publication

Typical application Level 2 use

Best know Method (BKM) Internal use

Troubleshooting guide Customer

II- Product
- Product range : - Product family :

Zelio R elay SSR

III- Introduction
Absolute protection of a solid state relay from a shorted load or line condition requires
more thought than simply providing a common circuit breaker or fuse in the circuit.

Compared to electromechanical switching devices, the solid state thyristor switching


elements used in the output section of a Solid State relay have very short thermal time
constants.
Consequently, extreme current levels and surges caused by load or line faults, even if only
applied over extremely short time periods, may cause the thyristor devices to permanently
fail.

Standard fuses and circuit breakers simply cannot react quickly enough to prevent the fault
current from exceeding the maximum levels that the thyristors can withstand.

Page 1/4
R007
V3.0
ZELIO RELAY

Page 2/4
R007
V3.0
ZELIO RELAY

IV- Description

The solid state relay manufacturers provide within their datasheets a specification value
that designates the maximum current vs. time that the thyristors can handle. This value is
commonly listed as ”I²t”, (amperes squared seconds).

Fuse manufacturers also give for certain types of fuses a “I²t” value: the energy required to
blow the fuse element. These fuses are generally called “Semiconductor” or “Ultra Fast
Acting”.
I²t parameters are provided by charts in manufacturer data sheets for each fuse range.
The energy is mainly dependent on current and time for fuses.

Assuming that the appropriate solid state relay has been selected for the particular
load parameters, the fuse selection can be made by considering:

1. The fuse voltage rating to accommodate the system voltage.

2. The fuse current rating, (considering normal running load, start-up surges,
operating temperatures, etc.)

3. The I²t rating of the selected solid state relay (data given in catalogue).

4. The I²t rating of the fuse. The “I²t” rating of the fuse must be below the I²t rating of the
selected solid state relay, and above the expected “normal” current surges of the load.

FUSE 63A
SSR PP8S75A2 I²T = 2770 A²s
I²T = 6000 A²s

It may happen on some occasions that the “normal” current and voltage ratings required of
the fuse push its I²t rating close to or beyond the I²t rating of the solid state relay.
If this is the case, a higher I²t rated solid state relay can be selected.

Page 3/4
R007
V3.0
ZELIO RELAY

As stated previously, this is a general method of determining adequate fusing for solid
state relays.

There are several other items that should be considered to complete the selection :
• The available fault current from the overall system.
• The amount of load surge cycling that will affect the cumulative heating of the fuse
itself.
• The peak “let-through” current of the fuse prior to clearing.

Fuse manufacturers such as Ferraz – Shawmut, Bussmann, Littlefuse, etc., publish


extensive notes detailing the calculations and methods of using those factors.

Page 4/4

You might also like