0% found this document useful (0 votes)
220 views3 pages

303-13 Evaporative Emissions - Removal and Installation - Evaporative Emission Canister

Uploaded by

CARLOS LIMADA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
220 views3 pages

303-13 Evaporative Emissions - Removal and Installation - Evaporative Emission Canister

Uploaded by

CARLOS LIMADA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Page 1 of 3

303-13 Evaporative Emissions - 2.3L EcoBoost (201kW/273PS) 2019 Ranger


Removal and Installation Procedure revision date: 10/15/2018

Evaporative Emission Canister

Base Part Number: 9E857

Removal

WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on
or near any fuel-related component. Highly flammable mixtures may be present and may be ignited.
Failure to follow these instructions may result in serious personal injury.

WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment
of any type when working on or near any fuel-related component. Highly flammable mixtures may be
present and may be ignited. Failure to follow these instructions may result in serious personal injury.

WARNING: Always disconnect the battery ground cable at the battery when working on an
evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures may be
present and may be ignited. Failure to follow these instructions may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

1. With the vehicle in NEUTRAL, position it on a hoist.


Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

2.
l Disconnect the EVAP canister electrical connector.
l Disconnect the vent hose.
l Disconnect the EVAP canister quick connect couplings.
Refer to: Quick Release Coupling (310-00 Fuel System - General Information - 2.3L EcoBoost
(201kW/273PS), General Procedures).

http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
Page 2 of 3

3.
1. Remove the fastener.
Torque: 133 lb.in (15 Nm)
2. Remove the EVAP canister.

Installation

http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
Page 3 of 3

1. To install, reverse the removal procedure.

Copyright © 2019 Ford Motor Company

http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019

You might also like