Scribd
Upload
11 views1 page

Feedback Lab 1'

The document provides steps to set up PLC software for programming, initialize RS LINX software, select COM ports, create and download a program, and become familiar with the SCP instruction and analog input/output signals in RS Logix 500.

Uploaded by

samrath grewal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
11 views1 page

Feedback Lab 1'

The document provides steps to set up PLC software for programming, initialize RS LINX software, select COM ports, create and download a program, and become familiar with the SCP instruction and analog input/output signals in RS Logix 500.

Uploaded by

samrath grewal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

LAB – FEEDBACK AND CONTROL

ABSTRACT
To learn the basic connection set up of PLC software before actually starting the programming a new file.
To understand all the necessary steps required to be followed so that plc can successfully communicate
with the system.

OBJECTIVE
To be able the set up the PLC software for programming.
To initialize the RS LINX software so that we can use RS LOGIX software.
To learn selection of COM ports.
To learn creating and downloading a program.
To become familiar with the SCP instruction and use of analog input and output signals in RS logix 500.

PROCEDURE
Turn on power supply.
Start RSLINX software.
Configure drivers and choose DH485 from available drivers.
Select the communication port to which plc is connected.
Open RS LOGIX 500 and select I/O configuration.
Click read I/0 configuration.
Configuration is done.
Software is ready for programming.

You might also like