Air Seperator
Air Seperator
AIR SEPARATOR
WWW.AURORAPUMP.COM
AIR SEPARATOR
Air Separator
The Air Removal Requirement. Cast Iron
2", 2½", 3"
Air is introduced to a hydronic system:
• During initial fill Water In
The remaining 4.5% air is released into the system as air pockets, bubbles, and
microbubbles, that can negatively impact the performance of fluid flow or heat Cast Iron
4" – 6"
transfer equipment.
Installation Schematics
Air Separators should be installed at the highest temperature and the lowest pressure points in the system. Where this is not possible, the
best location is at the point of highest temperature. Ideally, a separator should be located on the outlet side of the boiler and the suction side
of the pump.
WWW.AURORAPUMP.COM 3
Installation Schematics
For Heat Exchanger Applications
ST ER E D Q U
EGI
ALI
R
ISO 9001
TY SYSTEM
LIC
IN
AU
ST
IT
DR
UT
HY
19 17