Scribd
Upload
53 views

FPTM Operating Instructions

The document provides operating instructions for a fire pump test meter. The instructions include closing the system valve, opening the bypass valve and throttle valve, purging air from the meter by opening vent valves, starting the fire pump and reading the flow in GPM, and adjusting the throttle valve to meet pump requirements before closing valves after the test.

Uploaded by

anipo68
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
53 views

FPTM Operating Instructions

The document provides operating instructions for a fire pump test meter. The instructions include closing the system valve, opening the bypass valve and throttle valve, purging air from the meter by opening vent valves, starting the fire pump and reading the flow in GPM, and adjusting the throttle valve to meet pump requirements before closing valves after the test.

Uploaded by

anipo68
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

GERAND ENGINEERING CO.

2300 EDGEWOOD AVE S, MINNEAPOLIS, MN 55426 952.374.1320 WWW.GERAND.COM

Fire Pump Test Meter Operating Instructions

BRASS VENT VALVES


METER
PLASTIC VENT HOSE

CONNECTING HOSE

VENTURI

VENTURI SHUT-OFF VALVE

Attached to the meter with a brass chain is an oblong metal tag with the suggested piping diagram of the
system on one side, and the following operating instructions on the reverse side:

1. Close system OSY valve “A”


2. Open by-pass valve and “B” butterfly throttle valve
3. Purge meter, located on venturi, as follows:
a) Open station shut-off valves on venturi, and vent valves attached to meter.
When a steady stream of water without air bubbles passes through the clear plastic hoses,
the meter is purged of air.
b) Close the vent valves after purging.
4. Start the fire pump, and read meter in GPM.
5. Refer to pump GPM requirement and adjust throttle valve to meet the requirement.
6.After the test, open valve “A” and close the by-pass and “B” valves.

*SPECIFY RAISED OR FLAT FACE


GERAND GPM METER - VENTURI PACKAGE
“B” - Butterfly Throttle Valve OSY or Indicating
Butterfly Bypass Valve Flow SUGGESTED
TO RESERVOIR Air Vent PIPING
OR WASTE
DIAGRAM

(2) (5)
Optional to
Pump Inlet Min. Straight Pipe Diameters same line size as Venturi

OSY Valve “A” OSY Valve


Flow
Supply from
City Main or
Reservoir To System
FIRE PUMP

You might also like