10/6/22, 5:20 PM SIS 2.

2018/08/24 Maintenance Interval Schedule (SEBU8053-20)

SMCS - 7000 i07503308

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance
procedures are performed.

The user is responsible for the performance of maintenance. All adjustments, the use of proper lubricants, fluids, filters, and the replacement of
components due to normal wear and aging are included. Failure to adhere to proper maintenance intervals and procedures may result in
diminished performance of the product and/or accelerated wear of components.

Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products
that operate in severe operating conditions may require more frequent maintenance. Refer to the maintenance procedure for any other exceptions
that may change the maintenance intervals.

Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.

Note: If Cat HYDO Advanced hydraulic oil is used, the hydraulic oil change interval is 6000 service hours. S·O·S services after 3000 service hours
is strongly recommended.If Cat HYDO Advanced hydraulic oil is not used, the normal interval of 6000 hours is decreased to 2000 service hours or
1 year.Consult your Cat dealer for details.

When Required
Air Conditioner/Cab Heater Filter (Recirculation) - Inspect/Replace 

Battery - Recycle 

Battery or Battery Cable - Inspect/Replace 

Bucket Linkage - Inspect/Adjust 

Bucket Tips - Inspect/Replace 

Bucket Tips - Inspect/Replace 

Cab Air Filter (Fresh Air) - Clean/Replace 

Cab Air Filter (Fresh Air) - Clean/Replace 

Camera - Clean/Adjust 

Circuit Breakers - Reset 

Engine Air Filter Primary Element - Clean/Replace 

Engine Air Filter Secondary Element - Replace 

Fuel System - Prime 

Fuses - Replace 

High Intensity Discharge Lamp (HID) - Replace 

Oil Filter - Inspect 

Radiator Core - Clean 

Receiver Dryer (Refrigerant) - Replace 

Track Adjustment - Adjust 

Window Washer Reservoir - Fill 

Window Wiper - Inspect/Replace 

Windows - Clean 

Every 10 Service Hours or Daily for First 100 Hours

Boom and Stick Linkage - Lubricate 

Bucket Linkage - Lubricate 

Every 10 Service Hours or Daily

Cooling System Coolant Level - Check 

Engine Oil Level - Check 

Fuel System Water Separator - Drain 

Fuel Tank Water and Sediment - Drain 

Hydraulic System Oil Level - Check 

Indicators and Gauges - Test 

Seat Belt - Inspect 

Track Adjustment - Inspect 

Travel Alarm - Test 

Undercarriage - Check 

Every 10 Service Hours or Daily for Machines Used in Severe Applications

https://sis2.cat.com/#/print-preview/service/%257B%2522title%2522%253A%2522Maintenance%2520Interval%2520Schedule%2520(SEBU8053-20)%2522%252C%2522formattedPublicationDate%2522%253A%25… 1/4
10/6/22, 5:20 PM SIS 2.0

Bucket Linkage - Lubricate 

Every 50 Service Hours or Weekly

Boom and Stick Linkage - Lubricate 

Bucket Linkage - Inspect/Adjust 

Quick Coupler - Lubricate 

Every 100 Service Hours or 2 Weeks

Bucket Linkage - Lubricate 

Every 100 Service Hours of Continuous Hammer Use

Oil Filter (Hydraulic Hammer) - Replace 

Initial 250 Service Hours

Engine Valve Lash - Check 

Final Drive Oil - Change 

Hydraulic System Oil Filter (Case Drain) - Replace 

Hydraulic System Oil Filter (Pilot) - Replace 

Hydraulic System Oil Filter (Return) - Replace 

Swing Drive Oil - Change 

Every 250 Service Hours

Engine Oil Sample - Obtain 

Final Drive Oil Sample - Obtain 

Every 250 Service Hours for Machines Used in Severe Applications

Fuel System Primary Filter (Water Separator) Element - Replace 

Fuel System Secondary Filter - Replace 

Every 250 Service Hours or Monthly

Belt - Inspect/Adjust/Replace 

Condenser (Refrigerant) - Clean 

Final Drive Oil Level - Check 

Swing Bearing - Lubricate 

Swing Drive Oil Level - Check 

Every 250 Service Hours of Partial Hammer Use (50% of Service Hours)
Hydraulic System Oil Filter (Case Drain) - Replace 

Hydraulic System Oil Filter (Pilot) - Replace 

Oil Filter (Hydraulic Hammer) - Replace 

Every 250 Service Hours of Continuous Hammer Use

Hydraulic System Oil Filter (Case Drain) - Replace 

Hydraulic System Oil Filter (Pilot) - Replace 

Hydraulic System Oil Filter (Return) - Replace 

Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain 

Every 500 Service Hours

Cooling System Coolant Sample (Level 1) - Obtain 

Hydraulic System Oil Sample - Obtain 

Swing Drive Oil Sample - Obtain 

Every 500 Service Hours or 3 Months

Boom and Stick Linkage - Lubricate 

Engine Crankcase Breather - Clean 

Engine Oil and Filter - Change 

https://sis2.cat.com/#/print-preview/service/%257B%2522title%2522%253A%2522Maintenance%2520Interval%2520Schedule%2520(SEBU8053-20)%2522%252C%2522formattedPublicationDate%2522%253A%25… 2/4
10/6/22, 5:20 PM SIS 2.0

Fuel System Primary Filter (Water Separator) Element - Replace 

Fuel System Secondary Filter - Replace 
Fuel System Third Filter - Replace 
Fuel System Fourth Filter - Replace 
Fuel Tank Cap and Strainer - Clean 

Every 500 Service Hours of Partial Hammer Use (50% of Service Hours)
Hydraulic System Oil Filter (Case Drain) - Replace 

Hydraulic System Oil Filter (Pilot) - Replace 

Hydraulic System Oil Filter (Return) - Replace 

Every 600 Service Hours of Continuous Hammer Use

Hydraulic System Oil - Change 

Hydraulic System Oil Filter (Return) - Replace 

Every 1000 Service Hours or 6 Months

Battery - Clean 

Battery Electrolyte Level - Check 

Battery Hold-Down - Tighten 

Engine Valve Lash - Check 

Final Drive Oil Level - Check 

Hydraulic System Oil Filter (Case Drain) - Replace 

Hydraulic System Oil Filter (Pilot) - Replace 

Rollover Protective Structure (ROPS) - Inspect 

Swing Drive Oil - Change 

Every 1000 Service Hours of Partial Hammer Use (50% of Service Hours)
Hydraulic System Oil - Change 

Hydraulic System Oil Filter (Return) - Replace 

Every 2000 Service Hours or 1 Year

Final Drive Oil - Change 

Hydraulic System Oil Filter (Return) - Replace 

Hydraulic Tank Screen - Clean 

Receiver Dryer (Refrigerant) - Replace 

Swing Gear - Lubricate 

Every Year
Cooling System Coolant Sample (Level 2) - Obtain 

Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace 

Every 6000 Service Hours or 3 Years

Cooling System Coolant Extender (ELC) - Add 

Hydraulic System Oil - Change 

Every 12 000 Service Hours or 6 Years

Cooling System Coolant (ELC) - Change 

A6F1-UP, A8F1-UP, A9F1-UP, BZP1-UP, FAL1-UP, GDP1-UP, JPD1-UP, KGF1-UP, KHN1-UP, KLM1-UP, KTF1-UP, MCH1-UP, PCM1-UP, PCX1-
UP, PHX1-UP, SPN1-UP, TDH1-UP, WBN1-UP

PIP-11153680

2022/10/06

10:20:16+07:00

i05782407

© 2022 Caterpillar Inc.

Caterpillar:

Confidential Green
https://sis2.cat.com/#/print-preview/service/%257B%2522title%2522%253A%2522Maintenance%2520Interval%2520Schedule%2520(SEBU8053-20)%2522%252C%2522formattedPublicationDate%2522%253A%25… 3/4
10/6/22, 5:20 PM SIS 2.0

https://sis2.cat.com/#/print-preview/service/%257B%2522title%2522%253A%2522Maintenance%2520Interval%2520Schedule%2520(SEBU8053-20)%2522%252C%2522formattedPublicationDate%2522%253A%25… 4/4