Netsure 8100 DB Series Data Sheet
Netsure 8100 DB Series Data Sheet
Distribution Bay
NetSure™ 8100DB
NetSure™ 8100DB Series
(ILM) monitors all currents, identifying 16 128 Bullet 1 A to 300 A circuit breakers
alarms on the individual circuit breakers 16 128 TPS/TLS 3 A to 125 A bullet fuseholders
within that unit. Eight programmable 0 4 GMT 1.33 amp for ABS supply**
relays are provided that may be * Panels may be factory or field configured for either TPS or TPL fuses.
programmed to any or all of the alarm Each TPL fuseholder will take the place of two TPS fuseholders.
conditions. Alarms may be sent over ** Fuses supplied from factory.
Modbus or SNMP and thresholds are
remotely set via web pages, and all bus Options
designations are user configurable.
Option Description
Four GMT fuse positions are provided
for remote ABS loads as well as individual Single or Parallel Busses May be configured for 2, 4, 6 or 8 busses rated at 640 A continuous
GMT fuses on feeds to the meter and Adjustable Dressing Bars Sliding dressing bars for reduced output cable installation time
alarm panels, eliminating the need for Cable Management Kit Grooming kit for load cable dressing
inline fuses used in previous models. Transient Voltage Protection Bus voltage protection for sensitive electronic equipment
Options allow the bay to be ABS sourced Bottom Feed Air Block Provides insert for raised floor applications to block air flow.
internally or remotely. 2400 Amp Internal Return Bars Provides additional feeds at the opposite end and increases capacity
to 2400 A per side; comes with optional bonding strap
Factory Installed Hardware Hardware (flat. lock & nut) are factory installed on every stud
Hardware Kit Hardware provided in bulk, not installed in the factory
Vertiv.com | Vertiv Headquarters, 1050 Dearborn Drive, Columbus, OH, 43085, USA
© 2019 Vertiv Group Corp. All rights reserved. Vertiv™ and the Vertiv logo are trademarks or registered trademarks of Vertiv Group Corp. All other names and logos referred to are trade names, trademarks or registered trademarks of their respective owners. While every
precaution has been taken to ensure accuracy and completeness here, Vertiv Group Corp. assumes no responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications, rebates and other promotional
offers are subject to change at Vertiv’s sole discretion upon notice.
DC-00019 (R9/19)