Scribd
Upload
669 views

SE4310

This document provides diagnostic information for fault code 249:1410 from a Volvo A40F vehicle with serial numbers between 11001-99999. The fault indicates an issue with the bogie rear axle drive shaft speed sensor. Fault mode 3 detects a voltage above 4.7V which could be caused by an open circuit or short to higher voltage. Fault mode 4 detects a voltage below 0.3V which could be caused by a short to ground or defective sensor. The diagnostic steps are to check the sensor cable harness and sensor itself.

Uploaded by

Brando Imanuel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
669 views

SE4310

This document provides diagnostic information for fault code 249:1410 from a Volvo A40F vehicle with serial numbers between 11001-99999. The fault indicates an issue with the bogie rear axle drive shaft speed sensor. Fault mode 3 detects a voltage above 4.7V which could be caused by an open circuit or short to higher voltage. Fault mode 4 detects a voltage below 0.3V which could be caused by a short to ground or defective sensor. The diagnostic steps are to check the sensor cable harness and sensor itself.

Uploaded by

Brando Imanuel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Volvo Guided Diagnostics

Date: Information Type:


03/03/2022 Diagnostics Fault Codes 249: V2ECU 1410: Bogie rear axle drive shaft
speed
Profile:
A40F Volvo SN 11001-99999

MID249 PPID1410 / SE4310


Showing Selected Profile

Valid for serial numbers


Model Production site Serial number start Serial number stop
A40F Volvo SN 11001-99999

SAE code
MID/Control Unit MID249 V2ECU
PID/PPID/SID/PSID PPID1410 Bogie rear axle drive shaft speed
Machine display message
Text presentation SE4310

Reference ATC, description

Fault mode diagnosis

Fault mode Detection conditions:The vehicle control unit 2 (V2-ECU) registers: that the voltage is
FMI 3 above 4,7 V(V2B80)
Symptom: Possible causes:

¡ Longitudinal differential lock/six- ¡ Open circuit in cable harness


wheel drive (6x6) and control lamps ¡ Short circuit to higher voltage
activated ¡ Defective sensor
¡ No automatic control for the
differential locks

Action SE4310, description and measuring

Fault mode Detection conditions:The vehicle control unit 2 (V2-ECU) registers: that the voltage is
FMI 4 below 0,3 V(V2B80)
Symptom: Possible causes:

¡ Longitudinal differential lock/six- ¡ Short circuit to frame ground


wheel drive (6x6) and control lamps ¡ Defective sensor
activated
¡ No automatic control for the
differential locks

Action SE4310, description and measuring


Guided Diagnostics

You might also like