0% found this document useful (0 votes)
398 views1 page

Pipes and Fittings To Be Reported in Form WWO1149

Pipes and fittings to be reported in Form WWO 1149 for Hong Kong Water Supplier Department 30 March 2022

Uploaded by

Gary Wong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
398 views1 page

Pipes and Fittings To Be Reported in Form WWO1149

Pipes and fittings to be reported in Form WWO 1149 for Hong Kong Water Supplier Department 30 March 2022

Uploaded by

Gary Wong
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

(Updated as at 30 March 2022)

Pipes and fittings to be reported in Form WWO 1149 or Annex to Form WWO46 (1/2018)

A. GENERAL ACCEPTANCE (GA)


Currently Effective
 All pipes (in compliance with Part 1 of Schedule 2 in Waterworks Regulations)
 Copper pipe fittings (tee, bend, reducer, coupler and end cap only)
 Ductile iron pipe fittings (tee, bend and reducer only)
 PVC-U, PVC-C, PB, PE and PE-X pipe fittings (tee, bend and reducer only)
 Stainless steel pipe fittings (grooved type, press type and compression type for tee,
bend, reducer and coupler only)
 Expansion joint/settlement joint/flexible joint/rubber joint
 Fittings including (i) draw-off taps, (ii) stop valves, (iii) gate valves, (iv) ball valves
and (v) combination fittings
 Inlet flexible hose for tap/mixer only
 Valves including Pressure Reducing Valve, Butterfly valves, non-return valves/ check
valves, strainer
 Lead-free grade soldering materials
 Brazing materials
 Soldering flux
 Water Heater (instantaneous type)
 Fiberglass storage cistern (for potable water)
 Lining Materials of Potable Water Tanks (tile grout, ceramic tile, paint/coating and cementitious
products only) (please refer to the WSD Circular Letter No. 3/2019)
 Flow controller for tap/mixer1

From 1 September 2022


Additional items:
 Long-screw connector / Flange adaptor for water meter

B. WATER EFFICIENCY LABELLING SCHEME (WELS)


Currently Effective
 Prescribed water efficiency gradings for showers for bathing, water taps, urinal flushing valves2
(please refer to Chapter 7 of “Technical Requirements of Plumbing Works in Buildings”)
 Prescribed water efficiency gradings for water-closet fitments
(please refer to Chapter 7 of “Technical Requirements of Plumbing Works in Buildings”)
Note:
(1) Water Authority will update and expand the list when necessary.

1
For meeting prescribed water efficiency gradings as detailed in Part B.
2
For water taps or showers for bathing not complying with the prescribed water efficiency gradings, the WA accepts the
alternative of installing a flow controller (registered under WELS) inside the water tap or shower for bathing to form a ‘combined’
water saving device.

You might also like