Modul 6
Modul 6
Learning Objectives
• Add and edit annotations in drawing views.
• Add reference dimensions and notes to drawing views.
• Add surface finish and datum feature symbols to drawing views.
• Add geometric tolerance and datum target symbols to drawing views.
• Add center marks, callouts, and centerlines to drawing views.
• Add cosmetic threads and multi-jog leader to drawing views.
• Add dowel pin symbol to drawing views.
1
5/31/2013
• Source/Destination Rollout
• Dimensions Rollout
• Annotations Rollout
• Reference Geometry Rollout
• Options Rollout
• Layer Rollout
2
5/31/2013
3
5/31/2013
4
5/31/2013
Figure 8 The Properties dialog box used Figure 9 The Symbols flyout
to apply geometric tolerance used to define the geometric
condition symbols
5
5/31/2013
6
5/31/2013
Figure 14 Center marks added using Figure 15 Center marks added using
the Single Center Mark option the Linear Center Mark option
7
5/31/2013
8
5/31/2013
9
5/31/2013
• Editing Annotations
10
5/31/2013
11
5/31/2013
12
5/31/2013
13
5/31/2013
14
5/31/2013
Tutorial 1
In this tutorial, you will open the drawing created in Tutorial 1 of Chapter 14 and then
generate dimensions and add annotations to it. Next, you will change the display of the
front and the right view to make hidden lines visible. Finally, change the display of the
isometric view to the shaded mode. (Expected time: 45
min)
1. Copy the part document from Chapter 8 and the drawing document from Chapter
14 to the folder of the current chapter.
2. Configure the font settings and generate the dimensions using the Model Items tool.
3. Arrange the dimensions and delete the unwanted ones, refer to Figures 346 and 37.
Figure 36 Top view after generating Figure 37 Partial view of the sheet after
and arranging the dimensions generating and arranging the dimensions in
the aligned section view
15
5/31/2013
4. Add the datum symbol and geometric tolerance to the drawing views, refer to Figures 38
and 39.
5. Change the model display state of the drawing views, refer to Figure 40.
16
5/31/2013
Tutorial 2
In this tutorial, you will generate the BOM of Materials (BOM) of the Bench Vice
assembly and then add balloons to the isometric view in the exploded state.
(Expected time: 45 min)
1. Copy the Bench Vice folder that contains parts, assembly, and the drawing document,
from chapter 14 to the folder of the current chapter.
2. Delete the views that are not required in the drawing sheet, refer to Figure 42.
3. Move the views and arrange them in the drawing sheet, refer to Figure 42.
17
5/31/2013
18
5/31/2013
Exercise 1
Generate the isometric view in the exploded view of the assembly created in Tutorial 1
of Chapter 13 on the standard A4 sheet format. The scale of the view will be 1:5. After
generating the view, generate the BOM and add balloons to the assembly view shown
in Figure 45. (Expected time: 30 min)
19