Scribd
Upload
63 views1 page

Constraints Drawing Onshape

1. Three circles are arranged with their centers on the same horizontal plane. Circle 3 has a diameter of 2 inches and is tangent to circles 1 and 2. 2. Three parallel lines are made coincident with the centers of the circles. A line is drawn normal to one of the circles. 3. An equilateral triangle is formed by making the endpoints of one line coincident with the center of its associated circle.

Uploaded by

Prosper Nimley
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
63 views1 page

Constraints Drawing Onshape

1. Three circles are arranged with their centers on the same horizontal plane. Circle 3 has a diameter of 2 inches and is tangent to circles 1 and 2. 2. Three parallel lines are made coincident with the centers of the circles. A line is drawn normal to one of the circles. 3. An equilateral triangle is formed by making the endpoints of one line coincident with the center of its associated circle.

Uploaded by

Prosper Nimley
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

4 3 2 1

Dimension circle 3 to Ø2". Fix circles


Make all 3 lines Make the circle tangent to both lines.
Make Perpendicular 1 and 2. Make circle 3 tangent to
parallel to each other
circle 1 and circle 2.
D D
3

Fix the centerpoint of the circle. Make the circles


1 2
Make the endpoints of the line concentric.
coincident wtih the center of the circle.

Make lines horizonatal.


Make the line normal
C to the circle. C

Make lines vertical.


Make an equilateral triangle.
Make circles the same size. Arrange the centers of the circles on
the same horizontal plane.

B B

UNLESS OTHERWISE SPECIFIED, NAME DATE


DIMENSIONS ARE IN INCHES
.XX = ±.0- DRAWN NICHOLAS TERPACK 09/28/2020
.XXX = ±.00- ANGULAR = ± °
.XXXX = ±.000- FRACTIONAL = ±
CHECKED TITLE
SURFACE FINISH
APPROVED

DO NOT SCALE DRAWING


Geometric Constraints
A BREAK ALL SHARP EDGES AND
REMOVE BURRS
A
SIZE DWG NO. REV.
THIRD ANGLE PROJECTION MATERIAL FINISH
B 1
SCALE WEIGHT SHEET
1:1 1 of 1

4 3 2 1

You might also like