Scribd
Upload
49 views

Innovative Project Report Format - Updated

The project report describes a project titled "[Title of the Project]" that was completed to fulfill the requirements of the course "Innovative Project - Arduino using embedded C (CSE 1002)". The report includes an abstract, description of hardware and software used, block diagram and description of the project, results including images of the final model, challenges faced, and a conclusion. Hardware and software used include Arduino, sensors, and embedded C. The block diagram shows how components are connected and interact, and results demonstrate the working final device built by the group. Challenges in the approach and lessons learned are also discussed.

Uploaded by

Eshan S
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
49 views

Innovative Project Report Format - Updated

The project report describes a project titled "[Title of the Project]" that was completed to fulfill the requirements of the course "Innovative Project - Arduino using embedded C (CSE 1002)". The report includes an abstract, description of hardware and software used, block diagram and description of the project, results including images of the final model, challenges faced, and a conclusion. Hardware and software used include Arduino, sensors, and embedded C. The block diagram shows how components are connected and interact, and results demonstrate the working final device built by the group. Challenges in the approach and lessons learned are also discussed.

Uploaded by

Eshan S
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Itgalpura, Rajanukunte, Bengaluru - 560064

School of Engineering
A Project Report on

“Title of the Project”


Submitted in partial fulfillment of the requirement for the course
Innovative Project - Arduino using embedded C (CSE 1002)
Submitted by
Group:IPM/IPC XXX

Student Name Roll No

Under the supervision of

Guide name:
Designation:
Department:

2021-22
Abstract (100-150 words): Make sure all the paragraphs are justified in the document ( In case
if you don’t know what is justification in MS Word kindly google the same) -1page

Hardware, Software and tools used: The size of letters in all the paragraphs should be 12
and if there are sub headings its size should be 14.-1page

Block diagram & Description: Block Diagram of the project along with the Tinkercad model
(only if available) need to be included and describe the work done in few paragraphs. 2page-3page

Results (Model’s image): Results should have the image of the final device/model that was
built by your group. Discussion about the same in few paragraphs. One or more images can be uploaded
but unnecessary images will result in reduction of marks. -2 page-3page

Challenges faced: Here, the discussion should be related to the problems that are existing in the
approach 1 page

Conclusion: Conclude the project in a paragraph. 1 page

Instructions (DELETE this before submission)


 The whole length of the report should not exceed more than 10 pages.
 Font type should be times new roman

You might also like