Scribd
Upload
143 views

Training On Enercon Generator Control Panel

The document outlines a 40-hour, 5-day training on an Enercon generator control panel. The training will cover an overview of the control system, identifying components and operation philosophy on day 1. Day 2 focuses on the controller's description and operation as well as introducing the HMI. Day 3 introduces interconnects of the control system and basic troubleshooting. Day 4 involves operating the control panel while loaded and monitoring. Day 5 is for alarm and fault analysis, operation management, and troubleshooting and maintenance.

Uploaded by

Mahmudur Rahman
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
143 views

Training On Enercon Generator Control Panel

The document outlines a 40-hour, 5-day training on an Enercon generator control panel. The training will cover an overview of the control system, identifying components and operation philosophy on day 1. Day 2 focuses on the controller's description and operation as well as introducing the HMI. Day 3 introduces interconnects of the control system and basic troubleshooting. Day 4 involves operating the control panel while loaded and monitoring. Day 5 is for alarm and fault analysis, operation management, and troubleshooting and maintenance.

Uploaded by

Mahmudur Rahman
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Training on Enercon Generator Control Panel

Duration : 40 Hours (05 Day)


Location: At site.
Trained by: Enercon Asia Pte. Ltd.
Training summary:

Schedule Content Duration


Day-01 - Over view of Control system 08 hours.
- Device/component identity
- Operation philosophy
- Question review
Day-02 - Controller’s description 08 hours
- Controller’s operation
-HMI introduction
- Question review
Day-03 -Introduction with interconnections of control 08 hours
system.
-Introduction with control design for basic
troubleshooting.
- Question review

Day-04 -Operation of control panel at On-load 08 hours


-Observation and monitoring at On- load
- Question review

Day-05 -Alarm and Fault analysis 08 hours


-Operation Management
-Troubleshooting and Maintenance
- Question review

You might also like