MSDS Ic - Mec.1556
MSDS Ic - Mec.1556
2 . HAZARD IDENTIFICATION
General In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by
mouth to an unconscious person.
Inhalation Remove to fresh air, keep the patient warm and at rest.
Contact lenses should be removed. Irrigate copiously with clean, fresh water for at least 15
Eye contact minutes, holding the eyelids apart, and seek medical advice.
SAFETY DATA SHEET
Regulation (EC) No: 1907/2006-REACH
Version: Date of
1 Preperation:02/06/20
20 page 2 / 5
Remove contaminated clothing. Wash skin thoroughly with soap and water or use a proprietary
Skin contact skin cleaner. DO NOT use solvents and thinners.
Ingestion If accidentally swallowed obtain immediate medical attention. Keep at rest. DO NOT induce
vomiting.
Environmental Precautions
Do not allow to enter drains or water courses.
Keep the container tightly closed. Avoid skin and eye contact. For personal protection, see
Handling Section 8. Always keep in containers made of the same material as the supply container.
Store between 5 and 25°C in a dry, well ventilated place away from sources of heat,
Storage ignition and direct sunlight. Containers, which are opened should be properly resealed and
kept upright to prevent leakage.
Hand protection Wear protective gloves of polyvinyl alcohol, ethylenvinyl alcohol or Teflon.
Eye protection Eye protection designed to protect against liquid splashes should be worn.
Stable under the recommended storage and handling condition. Keep away from oxidizing agents and
strongly alkaline and strongly acidic materials to prevent the possibility of exothermic reaction. Keep dirty
wipers in a closed container.
11 . TOXICOLOGICAL INFORMATION
There is no data available on the product itself. It is formulated within the 64/548/EEC and
1999/45/EC guidelines Inhalation of aerosol may cause risk of chemical pneumonitis.Prolonged
contact with skin may cause flush, irritation and eczema
12 . ECOLOGICAL INFORMATION
When released into the soil, this material may leach into groundwater. When released into the soil,
this material may evaporate to a moderate extent. When released into water, this material may
biodegrade to a moderate extent. When released to water, this material is expected to quickly
evaporate. When released into the water, this material is expected to have a half-life of less than 1
day. This material has a log octanol-water partition coefficient of less than 3.0. This material is not
expected to significantly bioaccumulate. When released into the air, this material is expected to be
readily degraded by reaction with photochemically produced hydroxyl radicals. When released into the
air, this material may be moderately degraded by photolysis. When released into the air, this material
is expected to have a half- life between 1 and 10 days.
13 . DISPOSAL CONSIDERATIONS
Do not allow into drains or water courses or dispose of where ground or surface water may be
affected. Wastes, including emptied containers, are controlled wastes and should be disposed of in
accordance with regulations made under the Control and Pollution Act and the Environmental
Protection Act.
SAFETY DATA SHEET
Regulation (EC) No: 1907/2006-REACH
Version: Date of
1 Preperation:02/06/20
20 page 5 / 5
14 . TRANSPORT INFORMATION
15 . REGULATORY INFORMATION
Not applicable
16 . OTHER INFORMATION
The information contained in this safety data sheet is provided in accordance with the requirements of
the Chemicals (Hazard Information and Packaging) Regulations. The product should not be used for
purposes other than those shown in Section 1 without first referring to the supplier and obtaining written
handling instructions. As the specific conditions of use of the product are outside the supplier’s control,
the user is responsible for ensuring that requirements of relevant legislation are complied with. The
information contained in this material safety data sheet is based on the present state of knowledge and
current national legislation. It provides guidance on health, safety and environmental aspects of the
product and should not be construed as any guarantee of
technical performance or suitability for particular applications.
(N/A) Not available