Scribd
Upload
204 views

Bendix FGS 70 With AS395A HSI

This document provides a supplemental drawing for installing a GDC31 roll steering converter. It includes a schematic showing the connections between the GDC31 converter, an AS395A switch/annunciator panel, and an FGS70 autopilot system. The schematic details signal lines for AC reference power, heading error, lighting bus, serial communication, and ARINC 429 interfaces between the components. A note indicates this specific autopilot installation is not FAA certified and the drawing is for reference only.

Uploaded by

Seção Eletrica
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
204 views

Bendix FGS 70 With AS395A HSI

This document provides a supplemental drawing for installing a GDC31 roll steering converter. It includes a schematic showing the connections between the GDC31 converter, an AS395A switch/annunciator panel, and an FGS70 autopilot system. The schematic details signal lines for AC reference power, heading error, lighting bus, serial communication, and ARINC 429 interfaces between the components. A note indicates this specific autopilot installation is not FAA certified and the drawing is for reference only.

Uploaded by

Seção Eletrica
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

GDC31 Install Supplemental Drawing GDC31 Roll Steering Converter

SWITCH / ANNUN RSS CONVERTER ISOLATION FGS70


AS395A P10280 GDC31 COUPLER
1049-4801-01
P555 P580 P580
AC REF HI H- 40 4 26 VAC 400HZ
AC REF LO C- 41 26 VAC 400 HZ RETURN
HDG ERR HI H- 12 7 HDG COM
HDG ERR LO C- 13 10 HEADING ERROR
ISOLATION
2 COUPLER
1049-4801-01
4 1
SCHEMATIC
18 Ref 1 10
8 5 AP Out 3
1 3
1 12 Lamp A 4
11 24 Lamp B 5 4
5
12 15 AP Com 6
5 13
2 6
3 11 Prog Com 11 9 10
2 22 Gain Sel 0 14
RSC
LIGHTING BUS 6 13 Phase Sel 13
11
1 14 OR 28VDC
SWITCH / ANNUN 2A
14 12 14
P10280 7277-2-2
SCHEMATIC

7 3 Serial In
10 FOR GPS INPUT SEE APPENDIX C - GPS RECEIVER INTERCONNECT
4
5 16 Serial Com
8 2 ARINC 429 INPUT AVAILABLE ON PINS 7 & 8 ON PN 1049-4000-03 WITH SOFTWARE -001B OR LATER
1 25 Super Flag
HDG
7 429 RX-A 3 ARINC 429 OUTPUT AVAILABLE ON PINS 7 & 8 ON PN 1049-4000-01 WITH SOFTWARE -001A
3 2
6 GPS 8 429 RX-B 4 DASHED LINES BETWEEN HSI AND AUTOPILOT REPRESENT EXISTING WIRING - DO NOT REMOVE
12 11
20 429 SHIELD

Bendix FGS70 Autopilot w/ AS395A HSI

NOTE: THIS AUTOPILOT IS NOT STC’D – THIS DRAWING IS FOR REFERENCE ONLY!

You might also like