Audio Operational Amplifier

- MODEL2520
Specifications
Gain: Greater than 110 dB, DC
Frequency Response: Small signal
Gain Bandwldh Product- SO mHz
Full Output Frequency-40 kHz
Equivalent Input Noise: Less than 0.5 microvolts
Input Impedance: Greater than 10 megohms, DC
Input Current Offset: 25 nA Typ.; 75 nA Max.
Input Voltage Offset:• 4 mV Typ.; 10 mV Max.
Common Mode Input: ± 12 Volts with ± 15 VOC supply
± 15Volts with ± 20 voe supply
Distortion: 0.2% THO, 20 to 20,000 Hz
at rated output
Output Voltage: Greater than 7.75 Volts RMS,
± 15 VOC supply
Features Greater than 11 Volts RMS,
• Extremely low noise ± 20 voe supply
Minimum Load
• High output power Impedance: 750 for full output voltage
• Operation under a wide range of supply voltages
• Low quiescent current Continuous Power 0.8 Watts RMS@ ± 15 voe
Output: supply
• Low distortion (Minimum Load 1.s Watts RMS @ ± 20 voe
• Wide power bandwidth Impedance) supply
• Standard OP-AMP connections (Plug-In or P.C. mount)
Quiescent Current: 15 MIiiiamperes @ ± 15 voe
• Stable operating characteristics

--
supply
• Electrostatlcally shielded 26 Milliamperes @ ± 20 voe
• Short-Circuit and overload protected supply
Current at Rated Output 18 Milliamperes@ ± 15 voe
Applications 600 0 Load: supply
• Microphone Preamplifier• 32 Milliamperes @ ± 20 VOC
• Line or Booster Amplifiers supply
• Lossless Combining Amplifiers 75 0 load: 60 Milliamperes@ ± 15 voe
• Balanced TransformP.r~• Amplifiers supply
• Equallze rs and Equaliz a ~ - r s - 85 Milliamperes @ ± 20 VOC
• Earphone or Small Speaker Drivers
supply
Power Supply Voltage: Bl-polar, ± 12 VOC to ± 20 VOC
The Model 2520 is a high gain, wide band, direct coupled ·output offset may be nulled to zero by means of a 100 kfl trim
amplifier with differential input, designed specifically pot between the +v and T terminals. This is normally not nec-
for audio amplifier applications. Several Operational essary In Audio applications.
Amplifier circuits typical of those most often used In the
audio field are shown on the following page, along with
their characteristics. These circuits have been tested Our staff Is fully equipped and stands ready to provide
and the data shown has been validated in Automated engineering services, from applications assistance to com-
plete system design, and fabrication.
Processes laboratories.
The virtually perfect performance of the Model 2520 in
audio operational amplifier applications makes possible
the design of complete systems utilizing this low cost
device as the only active element.
Since Operational Amplifier circuits derive their char-
acteristics almost entirely from the performance of the
passive elements connected into the feedback loop, ac•
curate, predictable, and stable performance is assured.
The use of this single active plug-In element reduces
maintenance and service costs to a minimum.
The specially formulated, thermally conductive epoxy in
which this nine transistor amplifier is encapsulated, pro•
tects the internal circuitry against thermal shocks, vi-
bration and humidity. Conservative design based upon
" worst case analysis" plus thorough In-process inspec-
tion and performance test after "burn-In" assure long
life and reliable performance.

-f:>- Ml111MATEB PROt:EBBa111c.

-9,.>- # AUi/CUi111M, MEI.IIUI, ltlW,_ NI# ·511-114-1211 25205M973

www.SteamPoweredRadio.Com
 Circuit Specifications

,.
FIGURE1
GENERAL (Plgllt'N 1-1)
Load-■--; 8000
FNqUIIICI' R11paw: %0.25 dB, 20 to 20 kHz
at rated output power
LNa th■n 0.211. T-HD, 20 to 20 kHz
Dlllarllon:
at rated output power _______ A
t
£.IN
.L l
MICROPHONE PREAMPLIFIER (Figure 1)
Gain:
Equivalent Input
~ NolH:
58 dB
-129dBm, 20 to 20 kHz, unweighted
1 ( Input Impedance: Greater than 15000
Output Impedance: Less than 50
Power Output: +21 dBm, ±15 voe supply
+24 dBm, ± 20 voe supply
Mlc.ROPH0Nll ~ l f l U (V.IN: 56e)
------====== C. GtAltCA& a,il« t-XFMA,.~
FIGURE2
►..,,----,

LINE AMPLIFIER (Figure 2)

Gain: 49 dB
Equivalent Input - 125dBm, 20 to 20 kHz, unweighted
Noise:
Input Impedance: Greater than 2 megohms
Output Impedance: Less than 100fl
Power Output: +28 dBm, ± 15 voe supply
+30 dBm, ±20 voe supply

L INE. AMPLtP'IU ('-'IN :'l'N&)

LOSSLESS COMBINING AMPLIFIER (Figure 3)

Gain: 0 dB
Maximum Crosstalk: -100 dB
Maximum Gain: 20 dB for 10 Inputs

-
10 dB for 32 Inputs
" " " 20--11\/',~'"""41-4 Equivalent Input - 105 dBm for 10 Inputs
Noise: - 95 dBm for 32 Inputs
ll'UflolO-J\/411\,,........._,..,,,.~-- Input Impedance: 12k0
Output Impedance: Less than 50
Power Output: +21 dBm, ±15 voe supply
+24 dBm, ± 20 voe supply
Note: This circuit proo111::t~ a 180" phase reversal. An output
_ ~~ . , . : S l ~ that shown ln Figura 2 may be used
1\'IO"'

~ COMBINtNCi ~ ~
• ---- (~IN od:•:~: = = = ~ ~ ~ ; =
to::c: :o::rr:e::
:ct: :t::
he= ph=a=se
; ,; a;n~d::
c::
an=a:::l:ao=p=r=o:::
vl=d a=ad=d;lt;lo=n::
al::g::a::
ln::
. ::;i

FIGURl4 ~ :1'•-1\-
BALANCED TRANSFORMERLESS AMPLIFIER (Figure 4)
Gain: 40dB
Equivalent Input -124 dBm, 20 to 20 kHz.unweighted
t
'-tN
Noise:
Input Impedance:
Common Mode
6000
Greater than 90 dB

t"
Rej ection: (with matched resistors)

'
Maximum Common ± 8 Volts peak
Mode Voltage:
Output Impedance: Less than 20
Power Output: +21 dBm ± 15 voe supply
IOOp' + 24 dBm ± 20 voe supply
-
~
PICIURII
PHONO PREAMPLIFIER (Figure 5)
Equallzatlon: RIAA
Gain: 54 dB (2.5 mV at 1 kHz produces
+4 dBm output)
Input Impedance : 50kfl
Output Impedance : Less than 1000
Power Output: +25 dBm ± 15 voe supply
+28 dBm ± 20 VOe supply

PRINTED IN U.S.A. www.SteamPoweredRadio.Com ~ 1972 AUTOMATED PROCESSES, INC.