Scribd
Upload
82 views

Adm CS Evcc

This document summarizes the key specifications of an electric vehicle charge controller: - It supports multiple charging standards including SAE J1772, CHAdeMO, and CCS up to typical power inputs of 5W to 20W. - Interfaces include CAN bus, ventilator PWM, digital I/O, Ethernet, SD card, and charge stopping input. - The CCS and CHAdeMO interfaces support communication wires and temperature measurements with 3 PT1000 inputs. - The module has dimensions of 153 x 150 x 56 mm, is housed in an automotive IP67 rated enclosure, and weighs approximately 400g.

Uploaded by

Anvesh Ananthula
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
82 views

Adm CS Evcc

This document summarizes the key specifications of an electric vehicle charge controller: - It supports multiple charging standards including SAE J1772, CHAdeMO, and CCS up to typical power inputs of 5W to 20W. - Interfaces include CAN bus, ventilator PWM, digital I/O, Ethernet, SD card, and charge stopping input. - The CCS and CHAdeMO interfaces support communication wires and temperature measurements with 3 PT1000 inputs. - The module has dimensions of 153 x 150 x 56 mm, is housed in an automotive IP67 rated enclosure, and weighs approximately 400g.

Uploaded by

Anvesh Ananthula
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

EV Charge Controller (CCS)

• •
• •
• •
•
•
•
•
•
•
•
•
•
•
AC SAE J1772, IEC 61851-1
Charging Standards CHAdeMO Only on special request
CCS (Combo 1,2) DIN SPEC 70121, ISO 15118
Input voltage min / max 9V / 32V
Power input Recommended nominal 12V and 24 V systems
Typical / Peak consumption 5 W / 20W
CAN bus CAN 2.0B, extended addresses
Ventilator PWM 2 independent PWM channels
Digital Outputs 3 outputs, push-pull
Digital Inputs 2 inputs, 24V tolerant
LEDs 3 LED outputs, 12V, overcurrent protected
Interfaces (user side)
Ethernet 100Mbps RJ45
SD memory card 16 GB card standard
Charge Stop input HW charge disable (emergency)
Fast charging contactors 2 contactor drivers, externally powered
Wake up / Sleep Wake up on ignition, AC,CCS,CHAdeMO
Communication wires CP (Control Pilot), PP (Proximity Pilot)
Temperature measurements 3 PT1000 inputs
AC+CCS interface PLC (Powerline Communication) MStar / MediaTek GreenPHY
Output contactor driver 1 relay for driving output DC contactors
Protection HW interlocked relay (CP state monitor)
CHAdeMO interface Communication wires SEQ1, SEQ2, PROX, PERM, CANH, CANL
(not
(1) used currently) Temperature measurements 3 PT1000 inputs (shared with CCS inlet)
The minimum current depends on State of Charge and voltage of the EV battery, as this is a resonant converter
Module dimensions 153 x 150 x 56 mm
(2)
Derating and maximum operating temperature depends on the heatsink design, air or water cooling
Module housing Automotive, IP67
Mechanical
Connections CINCH automotive SHS series
Weight 400 g

You might also like