Part Catalog
Part Catalog
John Deere Plus-50™ II Engine Oil1 TY26669 26.0 L (7.0 gal) 500
John Deere Hydrau™ Hydrostatic System Oil1 TY27367 106.0 L (28.0 gal) 2000
John Deere Hydrau™ Hydraulic System Oil1 TY27367 106.0 L (28.0 gal) 2000
John Deere Hy-Gard™Inner Final Drive Oil (each side) TY6354 9.5 L (2.5 gal) 1000
750J (OSD)
John Deere Hy-Gard™ Inner Final Drive TY6354 9.5 L (2.5 gal) 1000
Oil (each side) 750J LT
John Deere Hy-Gard™ Inner Final Drive Oil (each side) TY6354 15.9 L (4.2 gal) 1000
750J WT and 750J LGP
John Deere Hy-Gard™ Outer Final Drive Oil1 (each TY6354 15.1 L (4.0 gal) 1000
side)
John Deere Hy-Gard™ Track Frame Pivot Shaft Oil1 TY6354 1.7 L (1.75 qt) 1000
(each side)
Apr 2022. Release Date. *See operator’s manual for addional details.
REPLACEMENT PARTS GUIDE
750J Crawler Dozer (PIN: 1T0750JX_ _D141344—310257)
Apr 2022. Release Date. *See operator’s manual for addional details.
UPTIME MAINTENANCE PLANNER
Service Intervals
Service Intervals
750J Crawler Dozer (PIN: 1T0750JX_ _D141344—310257)
As Required
□ Inspect belts □ Check engine air cleaner restriction indicator
□ Check and adjust trunnion bearing clearance (if equipped) □ Check and adjust track sag
□ Clean or replace engine air cleaner elements □ Add coolant extender as indicated by Cool-Gard™ II test strips
Every 10 Hours or Daily
□ Check engine oil level □ Lubricate C-frame dozer linkage (if equipped)
□ Check coolant level at surge tank □ Lubricate pushbeam dozer linkage (if equipped)
□ Check transmission oil level □ Check hydraulic system oil level
□ Check and drain auxiliary fuel filter and water separator (if equipped) □ Check and drain primary fuel filter
Every 50 Hours
□ Lubricate lift cylinder pivots □ Lubricate rear ripper (if equipped)
□ Lubricate left and right end crossbar pivot
Initial Service—250 Hours1
□ Drain and refill break-in engine and replace filter
Every 250 Hours
□ Take engine oil sample □ Check inner and outer final drive oil level
Every 500 Hours
□ Check air intake hoses □ Take hydraulic oil sample
□ Replace primary and final fuel filters □ Take diesel fuel sample
□ Drain and refill engine oil and replace filter □ Take engine coolant sample
□ Check fuel fired coolant heater (if equipped) □ Take transmission oil sample
□ Check battery water level; clean and tighten terminals □ Take inner and outer final drive oil sample
□ Replace auxiliary fuel filter and water separator (if equipped)
Every 1000 Hours
□ Check coolant □ Clean engine crankcase vent tube
□ Drain and refill inner and outer final drive oil □ Check track frame pivot shaft bushing oil
Every 2000 Hours
□ Check and adjust engine valve lash □ Replace hydrostatic charge filter
□ Replace hydraulic fan oil return filter □ Drain and refill hydrostatic transmission oil
□ Drain and refill hydraulic system oil and replace filter
Every 6000 Hours
□ Drain, flush, and refill engine cooling system
Cool-Gard is a trademark of Deere & Company
MB60223,0005271 -19-01OCT19-1/1
Apr 2022. Release Date. *See operator’s manual for addional details.