Scribd
Upload
323 views4 pages

001-023 Crankshaft Seal, Front

Uploaded by

Yè Winț
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
323 views4 pages

001-023 Crankshaft Seal, Front

Uploaded by

Yè Winț
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

001-

001-023 Crankshaft Seal, Front

Install

NOTE:
NOTE: "LDL TFE" (Lay-
(Lay-Down Lip,
Teflon™) oil seals for service
replacement have an assembly tool
which protects the seal lip during
shipment and installation. The "LDL
TFE" oil seal must be installed with
the lip of the seal and the
crankshaft clean and dry. Do not
use any lubricant. The use of
lubricant will result in oil leakage at
the seal.

The installation procedure for


the crankshaft oil seal varies
when used with or without a
wear sleeve.

Seal (No Wear Sleeve) Installation

A seal without a wear sleeve


may be used on new
crankshafts, or used crankshafts
having wear grooves less than
0.005" deep.
Use the installation sleeve
provided with the seal to install
the seal partially onto the
crankshaft.
After installing the oil seal onto
the installation sleeve, fit the
sleeve over the nose of the
crankshaft. Use hand pressure to
transfer the oil seal over the
installation sleeve onto the
crankshaft as far as possible.
Remove the installation sleeve
from the nose of the crankshaft.

Install the included 3/16 inch


spacer ring, Part Number
4919687, onto the top plate,
Part Number ST-1259-1, with
the three allen head screws,
Part Number ST-1259-3,
provided.
Install the top plate, Part
Number ST-1259, (with a
3/16 inch spacer mounted) to
the crankshaft, using three
vibration damper mounting
capscrews and flat washers.
Tighten the three capscrews
alternately in 1/2-turn
increments until the oil seal is
installed flush with the gear
cover bore.
Seal (with Wear Sleeve) Installation

Install the included 3/16 spacer,


Part Number 4919687, onto the
top plate, Part Number ST-1259-
1. Use the three allen head
screws provided, Part Number
ST-1259-3.
Install the wear sleeve onto the
seal using the plastic guide that
is provided in the seal kit.
Apply a thin layer of sealant,
such as Dow™ 736 or
equivalent, to the wear sleeve
and to the crankshaft where the
wear sleeve will seat.

Fit the top plate (with spacer)


and the seal (with wear sleeve)
to the crankshaft using three
included capscrews, Part
Number S-123-A, and flat
washers.

NOTE:
NOTE: Make sure the wear sleeve and
seal are even before starting
installation or damage to the wear
sleeve can occur.

Tighten the three capscrews


alternately in half turn
increments until the oil seal is
installed flush with the gear
cover bore.
Clean any excess sealant from
the crankshaft and seal.

Install the dust excluder seal


by hand, flush to +0.38 mm
[+0.015 inch] from the case
of the oil seal.

NOTE:
NOTE: The dust excluder must be
installed dry. Do not use any
lubricant.

Last Modified: 04-


04-Oct-
Oct-2011

Copyright © 2000-2010 Cummins Inc. All rights reserved.

You might also like