SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

SECTION 1. PRODUCT AND COMPANY IDENTIFICATION

Product name: ROYCO 81MS MIL-DTL-25681E

MOLYBDENUM DISULFIDE & SILICONE LUBE OIL

Product Use Description: Lubricant

Company: Manufacturer
Anderol Specialty Lubricants, a division of Chemtura Corporation
215 Merry Lane
East Hanover, NJ
07936
United States of America

Telephone: +1 203-573-4596, Toll Free: +1 888-263-3765

Emergency telephone CHEMTREC: (24 hours) 800-424-9300

number: :
: 703-527-3887

For additional emergency telephone numbers see section 16 of the Safety

Data Sheet.

Prepared by Product Safety Department

(US) +1 866-430-2775

[email protected]

Recommended use of the chemical and restrictions on use

Recommended use : Lubricant

Restrictions on use : For use in industrial installations only.

SECTION 2. HAZARDS IDENTIFICATION

Form paste
Colour No data available
Odour odourless

GHS Classification
Not a hazardous substance or mixture.

GHS Label element

SAP 6.0 SDS 2012-2 NA GHS 1/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

Other hazards : None

Not a hazardous substance or mixture.

Self-ignitable : No data available

Carcinogenicity:
IARC No component of this product present at levels greater than or
equal to 0.1% is identified as probable, possible or confirmed
human carcinogen by IARC.
OSHA No component of this product present at levels greater than or
equal to 0.1% is identified as a carcinogen or potential
carcinogen by OSHA.
NTP No component of this product present at levels greater than or
equal to 0.1% is identified as a known or anticipated carcinogen
by NTP.

SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Hazardous components

Chemical Name CAS-No. Concentration (%)

molybdenum disulphide 1317-33-5 >= 30 - < 50 %

SECTION 4. FIRST AID MEASURES

If inhaled : Remove to fresh air.

Aspiration may cause pulmonary oedema and pneumonitis.
If breathing is difficult, give oxygen.
If symptoms persist, call a physician.

In case of skin contact : Wash off with warm water and soap.
If skin irritation persists, call a physician.
Cool skin rapidly with cold water after contact with molten
material.

In case of eye contact : Rinse immediately with plenty of water, also under the eyelids,
for at least 15 minutes.
Get medical attention immediately.

If swallowed : Do NOT induce vomiting.

Obtain medical attention.
Never give anything by mouth to an unconscious person.

Most important symptoms : None known.

and effects, both acute and
delayed
Notes to physician : For specialist advice physicians should contact the Poisons
Information Service.

SAP 6.0 SDS 2012-2 NA GHS 2/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

SECTION 5. FIREFIGHTING MEASURES

Suitable extinguishing media : (on small fires)

Carbon dioxide (CO2)
Dry chemical
Dry sand
Extinguishing media - large fires
Water mist
Foam

Unsuitable extinguishing : Water spray jet

media

Specific hazards during : Burning produces irritant fumes.

firefighting Exposure to decomposition products may be a hazard to
health.

Specific extinguishing : Cool containers/tanks with water spray.

methods

Special protective equipment : Self-contained breathing apparatus with full face-piece

for firefighters operated in positive pressure mode.
Body covering protective clothing, full "turn-out" gear.

SECTION 6. ACCIDENTAL RELEASE MEASURES

Personal precautions, : Wear suitable protective equipment.

protective equipment and
emergency procedures

Environmental precautions : Should not be released into the environment.

Do not flush into surface water or sanitary sewer system.

Methods and materials for : Dam up. Soak up with inert absorbent material (e.g. sand,
containment and cleaning up silica gel, acid binder, universal binder, sawdust). Pick up and
transfer to properly labelled containers.

SECTION 7. HANDLING AND STORAGE

Advice on safe handling : Handle in accordance with good industrial hygiene and safety
practice.
Wear suitable protective equipment.
Avoid contact with skin, eyes and clothing.
Keep tightly closed.
Protect from contamination.

SAP 6.0 SDS 2012-2 NA GHS 3/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

Conditions for safe storage : Keep tightly closed in a dry, cool and well-ventilated place.

Materials to avoid : Strong oxidizing agents

SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Components with workplace control parameters

Basis
Components CAS-No. Form of Permissible
exposure concentration
molybdenum disulphide 1317-33-5 TWA (total 15 mg/m3 OSHA Z-1
dust)
TWA 10 mg/m3 ACGIH
(Inhalable
fraction)
TWA 3 mg/m3 ACGIH
(Respirable
fraction)
TWA (Total 10 mg/m3 OSHA P0
dust)

Engineering measures : Use with adequate ventilation.

Personal protective equipment

Respiratory protection : No personal respiratory protective equipment normally
required.

Hand protection
Remarks : When handling hot material, use heat resistant gloves.

Eye protection : Safety goggles

Skin and body protection : impervious clothing

Hygiene measures : Handle in accordance with good industrial hygiene and safety
practice.
Use only with adequate ventilation.
Avoid breathing vapours, mist or gas.

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance : paste

Color : No data available

Odor : odourless
Odour Threshold : No data available

SAP 6.0 SDS 2012-2 NA GHS 4/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

pH : No data available
Melting point/range :
No data available
Boiling point/boiling range : No data available
Evaporation rate : No data available
Flash point : > 300 °C
Method: open cup

Auto-flammability : No data available

Upper explosion limit : No data available
Lower explosion limit : No data available
Vapour pressure : Not applicable
Relative vapour density : No data available
Relative density : >1
Solubility(ies)
Water solubility : negligible
Solubility in other solvents : partly soluble

Partition coefficient: n- : No data available

octanol/water
Auto-ignition temperature : not determined
Thermal decomposition : No data available

Viscosity
Viscosity, dynamic : No data available
Viscosity, kinematic : No data available

SECTION 10. STABILITY AND REACTIVITY

Reactivity : No dangerous reaction known under conditions of normal use.

Chemical stability : No decomposition if stored and applied as directed.

Possibility of hazardous : Hazardous polymerisation does not occur.

reactions
Conditions to avoid : Contamination

Incompatible materials : Strong oxidizing agents

Hazardous decomposition : Oxides of calcium

products Sulphur oxides
Carbon oxides

SAP 6.0 SDS 2012-2 NA GHS 5/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

SECTION 11. TOXICOLOGICAL INFORMATION

Aspiration toxicity (Product) : No aspiration toxicity classification

Further information (Product) : No data is available on the product itself.

SECTION 12. ECOLOGICAL INFORMATION

Ecotoxicity effects

Toxicity to fish (Product) : Remarks:

No data available

Toxicity to daphnia and other : Remarks:

aquatic invertebrates No data is available on the product itself.
(Product)

Elimination information (persistence and degradability)

Bioaccumulation (Product) : Remarks:

No data available

Mobility (Product) : Remarks:

No data available

Biodegradability (Product) : Result: No data available

Further information on ecology

Ecotoxicology Assessment
Results of PBT assessment (Product)
This mixture contains no substance considered to be persistent, bioaccumulating and toxic (PBT).
Additional ecological : No information on ecology is available.
information (Product)

SECTION 13. DISPOSAL CONSIDERATIONS

Disposal methods
Waste from residues : In accordance with local and national regulations.
SAP 6.0 SDS 2012-2 NA GHS 6/8 SDS Number: 400000001793
 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

SECTION 14. TRANSPORT INFORMATION

ADR
Not dangerous goods

RID
Not dangerous goods

MERCOSUR
Not dangerous goods

DOT
Not dangerous goods

IATA
Not dangerous goods

IMDG
Not dangerous goods

SECTION 15. REGULATORY INFORMATION

TSCA list : Not relevant

Not relevant

EPCRA - Emergency Planning and Community Right-to-Know Act

CERCLA Reportable Quantity

This material does not contain any components with a CERCLA RQ.
SARA304 Reportable Quantity
This material does not contain any components with a section 304 EHS RQ.

SARA 311/312 Hazards : No SARA Hazards

SARA 302 : No chemicals in this material are subject to the reporting

requirements of SARA Title III, Section 302.

SARA 313 : This material does not contain any chemical components with
known CAS numbers that exceed the threshold (De Minimis)
reporting levels established by SARA Title III, Section 313.

SAP 6.0 SDS 2012-2 NA GHS 7/8 SDS Number: 400000001793

 SAFETY DATA SHEET

ROYCO 81MS MIL-DTL-25681E

Version: 1.1 Revision Date: 07/14/2015 Print Date: 07/17/2016

US State Regulations
California Prop 65 This product does not contain any chemicals known to State of
California to cause cancer, birth defects, or any other
reproductive harm.
The components of this product are reported in the following inventories:
US.TSCA On TSCA Inventory
DSL All components of this product are on the Canadian DSL.
AICS On the inventory, or in compliance with the inventory
NZIoC On the inventory, or in compliance with the inventory
ENCS On the inventory, or in compliance with the inventory
KECI On the inventory, or in compliance with the inventory
PICCS On the inventory, or in compliance with the inventory
IECSC On the inventory, or in compliance with the inventory

SECTION 16. OTHER INFORMATION

Further information

Other Emergency Phone Number

Latin America: Brazil +55 113 711 9144

All other countries +44 (0) 1235 239 670
Mexico: +52 555 004 8763

The information provided in this Safety Data Sheet is correct to the best of our knowledge,
information and belief at the date of its publication. The information given is designed only as
a guidance for safe handling, use, processing, storage, transportation, disposal and release
and is not to be considered a warranty or quality specification. The information relates only to
the specific material designated and may not be valid for such material used in combination
with any other materials or in any process, unless specified in the text.

SAP 6.0 SDS 2012-2 NA GHS 8/8 SDS Number: 400000001793