Data Sheet

Cisco ASR 9000 Series 4-Port 100-Gigabit

Ethernet LAN Line Card
Product overview
Cisco® ASR 9000 4-port 100 Gigabit Ethernet LAN line card delivers line-rate 100 Gigabit Ethernet ports to any slot
of a Cisco ASR 9000 Series Aggregation Services Router. This line card provides carrier-class reliability and is
designed to remove bandwidth bottlenecks in the network that are caused by a large increase in Video-on-Demand
(VoD), IPTV, point-to-point video, Internet video, and cloud services traffic. This 4-port 100 Gigabit line card uses
100G Quad Small Form Factor Pluggable (QSFP) optics. It also provides the flexibility to break 100GE ports into
four 10GE channels for a total of 16 10GE channels per line card. Using a “green design,” this low powered line
card further allows customers put an unused slice in power-saving mode to reduce power consumption. With these
capabilities, the ASR 9000 Series 4-port 100-GE LAN line card (Figure 1) provides the fundamental infrastructure
for scalable Carrier Ethernet and IP/Multiprotocol Label Switching (IP/MPLS) networks, promoting profitable
business, residential, and mobile services.

Figure 1. Cisco ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line card

Features and benefits

The ASR 9000 Series 4-port 100-GE LAN line card are fully compatible with the ASR 9006, ASR 9010, ASR 9904,
ASR 9906, ASR 9910, ASR 9912 and ASR 9922 Routers. These line cards are designed for transport integration
in high-density 100G environments, deliver line-rate packet performance for IP and MPLS transport, and operate at
an incredibly low-power profile, thereby lowering total network operating expenses.

The ASR 9000 Series can extend 100 Gigabit Ethernet transport over an IP-over-Dense-Wave-Division-
Multiplexing (IPoDWDM) network when used with the Cisco ONS 15454 DWDM transponder solution. Distances of
up to 3000 kilometers can be achieved while using the optical protection capabilities of the DWDM network.

Table 1 lists the features and benefits of the Cisco ASR 9000 Series line card. Specific feature and scale support is
hardware- and software-dependent.

Table 1. Features and benefits of Cisco ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line card

Feature Benefit
Interface support
QSFP 100G pluggable interfaces Standard QSFP28 100 Gigabit Ethernet optics. For a complete list of supported interfaces, see the Cisco
ASR 9000 Transceiver Modules: Line Card Support data sheet
Layer 3 services Combined IP, MPLS, Ethernet, and Layer 3 VPN (L3VPN) services

© 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 1 of 4
 Feature Benefit

Evolutionary monitoring
Carrier-class Operations, NetFlow, IEEE 802.1ag, IEEE 802.3ah, ITU Y.1731, IP Service-Level Agreement (IP SLA), Virtual Circuit
Administration, and Maintenance Connectivity Verification (VCCV), ping, and traceroute
(OAM)
Carrier-Class OS
Cisco IOS® XR Software Modular, patchable, scalable, highly available, carrier-core and edge-proven operating system

Product specifications
Table 2 provides product specifications for the ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line card.

Table 2. Product specifications

Description Specification
Chassis compatibility Compatible with the Cisco ASR 9006, ASR 9010, ASR 9904, ASR 9906, ASR 9910, ASR 9912, and ASR
9922 chassis

Port density 4 ports of 100 Gigabit Ethernet or 16 10GE ports via breakout per line card
Ethernet ● 100-Gbps IEEE 802.3ba compliant
● 100 Gigabit Ethernet PHY monitoring
● IEEE 802.x flow control
● Full-duplex operation
● Per-port byte and packet counters for policy drops; oversubscription drops; Cyclic Redundancy Check
(CRC) error drops; packet sizes; and unicast, multicast, and broadcast packets
Performance ● 100-Gbps line-rate throughput per port

Reliability and availability Line card Online Insertion and Removal (OIR) support without system impact

Physical dimensions (H x W x D); 4-port 100 Gigabit Ethernet LAN line card: 14.5 x 1.63 x 22.02 in.; 19.7 lb (368.3 mm x 41.4 mm x 559.3
weight mm; 8.9 kg)
Operating temperature 41 to 104ºF (5 to 40ºC)

Operating humidity (nominal) 10 to 85%

(relative humidity)
Storage temperature –40 to 158ºF (–40 to 70ºC)

Storage (relative humidity) 5 to 95%

Note: Not to exceed 0.024 kg of water per kg of dry air
Operating altitude –60 to 4000m (up to 2000m conforms to IEC, EN, UL, and CSA 60950 requirements)
ETSI standards Cisco ASR 9000 Series Routers are designed to meet:
● EN300 386: Telecommunications Network Equipment (EMC)
● ETSI 300 019 Storage Class 1.1
● ETSI 300 019 Transportation Class 2.3
● ETSI 300 019 Stationary Use Class 3.1
● EN55022: Information Technology Equipment (Emissions)
● EN55032: Multimedia Equipment (Emissions)
● EN55024: Information Technology Equipment (Immunity)
● EN55035: Multimedia Equipment (Immunity)
● EN50082-1/EN-61000-6-1: Generic Immunity Standard

EMC standards Cisco ASR 9000 Series Routers are designed to meet:
● FCC Class A
● ICES 003 Class A
● AS/NZS 3548 Class A
● CISPR 22 (EN55022) Class A
● CISPR 32 (EN55032) Class A
● VCCI Class A
● BSMI Class A
● IEC/EN 61000-3-2: Power Line Harmonics
● IEC/EN 61000-3-3: Voltage Fluctuations and Flicker

© 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 2 of 4
 Description Specification
Immunity Cisco ASR 9000 Series Routers are designed to meet:
● IEC/EN-61000-4-2: Electrostatic Discharge Immunity (8kV Contact, 15kV Air)
● IEC/EN-61000-4-3: Radiated Immunity (10V/m)
● IEC/EN-61000-4-4: Electrical Fast Transient Immunity (2kV Power, 1kV Signal)
● IEC/EN-61000-4-5: Surge AC Port (4kV CM, 2kV DM)
● IEC/EN-61000-4-5: Signal Ports (1kV)
● IEC/EN-61000-4-5: Surge DC Port (1kV)
● IEC/EN-61000-4-6: Immunity to Conducted Disturbances (10Vrms)
● IEC/EN-61000-4-8: Power Frequency Magnetic Field Immunity (30A/m)
● IEC/EN-61000-4-11: Voltage DIPS, Short Interruptions, and Voltage Variations

Safety Cisco ASR 9000 Series Routers are designed to meet:

● UL/CSA/IEC/EN 60950-1
● IEC/EN 60825 Laser Safety
● ACA TS001
● AS/NZS 60950
● FDA: Code of Federal Regulations Laser Safety

Pluggable interfaces
The ASR 9000 Series 4-port 100 Gigabit Ethernet line card supports the QSFP form factor pluggable interfaces
listed in Table 3. See the Cisco ASR 9000 Transceiver Modules: Line Card Support data sheet for a complete list
of supported pluggable interfaces.

Table 3. Cisco interfaces supported by the Cisco ASR 9000 Series 4-port 100 Gigabit Ethernet line card

Part number 100 Gigabit Ethernet QSFP optics Maximum Distance

QSFP-100G-LR4-S 100 Gigabit Ethernet long-reach, 1310 nm single-mode fiber 10 km

QSFP-100G-SR4-S 100 Gigabit Ethernet short-reach, 850 nm multimode fiber 100 – 150 m
QSFP-100G-CWDM4-S 100GBASE CWDM4 QSFP Transceiver, LC, 2 km over SMF 10 km

QSFP-100G-AOC10M 100GBASE QSFP Active Optical Cable, 10m 10 m

*
QSFP-4X10G-LR-S QSFP 4x10G Transceiver Module, SM MPO, 10KM, Enterprise-Class 10 km
QSFP-100G-ER4L-S* 100GBASE QSFP Transceiver, 40KM reach over SMF, Duplex LC 40 km
*
There are minimum XR release requirements to support these optics

Software licensing
Line card feature licenses
The ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line cards support optional per-line-card feature licenses to
turn on advanced features. Layer 3 VPN licenses provide access to VPN Routing and Forwarding (VRF) instances
on a per-line-card basis. They include the Infrastructure VRF license to support up to eight VRF instances and
Advanced IP licenses to support up to full-scale VRF instances. Table 4 lists the line card feature licenses.

Table 4. Feature licenses for Cisco ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line card

License part number Feature description

A9K-400G-IVRF ASR 9000 4-port 100GE Infrastructure VRF license

A9K-400G-L-AIP ASR 9000 4-port 100GE Advanced IP license per line card

© 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 3 of 4
 Table 5 provides ordering information for the ASR 9000 Series 4-port 100 Gigabit Ethernet LAN line card.

Table 5. Ordering information

Product description Part number Minimum XR Release support

Cisco ASR 9000 4-port 100GE LAN line card A9K-4X100GE XR 6.2.3

Downloading the software

Visit the Cisco Software Center to download Cisco IOS Software.

Cisco Services for the Cisco ASR 9000 Series

Through a lifecycle services approach, Cisco delivers comprehensive support to service providers to help you
successfully deploy, operate, and optimize your Cisco IP Next-Generation Networks. Cisco Services for the Cisco
ASR 9000 Series Aggregation Services Routers provide services and proven methodologies that help ensure
service deployment with substantial return on investment, operational excellence, optimal performance, and high
availability. These services are delivered using leading practices, tools, processes, and lab environments
developed specifically for ASR 9000 Series deployments and post-implementation support. The Cisco Services
team addresses your specific requirements, mitigates risk to existing revenue-generating services, and helps
accelerate time to market for new network services.

Cisco Capital
Flexible payment solutions to help you achieve your objectives.
Cisco Capital makes it easier to get the right technology to achieve your objectives, enable business transformation
and help you stay competitive. We can help you reduce the total cost of ownership, conserve capital, and
accelerate growth. In more than 100 countries, our flexible payment solutions can help you acquire hardware,
software, services and complementary third-party equipment in easy, predictable payments. Learn more.

For more information

For more information about Cisco Services, contact your local Cisco account representative or visit
https://www.cisco.com/go/spservices.

Printed in USA C78-740092-01 08/18

© 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 4 of 4