Manually Set MRZP For TR Using A C Configuration
Manually Set MRZP For TR Using A C Configuration
configuration
Translation
Available
The rotary must be positioned as shown, using the A axis for tilt, the C axis for rotary, and with the A axis parallel to the machine X
axis.
The A axis tool change offset must be set such that the rotary platter is parallel to the machine XY plane.
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On June 08, 2018 1/4
STEP 1
1. Using handle jog, position the spindle probe in the center of the rotary
platter center bore.
2. Using VPS, probe the rotary platter center bore and store the resulting
X and Y coordinates in G54
STEP 2
STEP 3
2. Using handle jog, position the spindle probe next to the face of the
rotary platter.
3. Using VPS, probe the rotary platter face Y position and store the result
in G57
5. Using handle jog, position the spindle probe next to the face of the
rotary platter.
6. Using VPS, probe the rotary platter face Y position and store the result
in G58
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On June 08, 2018 2/4
STEP 4
2. Using handle jog, position the spindle probe above the face of the
rotary platter.
3. Using VPS, probe the rotary platter face Z position and store the result
in G57.
STEP 5
1. perform the following calculation: (G57 Y + G58 Y)/2). Copy the result
into setting 301 (MZRP Y Offset Master)
3. You may use the forms found in Step 6 to keep track of the values
output by the probe.
STEP 6
302 (MZRP Z Offset Master) ____ = G57 Z ____ - ((G57 Y ____ - G58 Y
____) / 2)
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On June 08, 2018 3/4