Scribd
Upload
250 views4 pages

NT Bosch Edc17c19 Irom TC1792 Opel 1033

The document provides instructions for connecting to the ECU of an Opel vehicle. It specifies using cable CABLE F32GN037C and ensuring the power LED on the device is on. For DIMA connection an F34DM011 adapter is required, with the boot pin connected to pad 10 and boot switch in the on position. Alternatively the boot wire can connect directly to the orange boot clamp on the adapter.

Uploaded by

MOFIDE JAWDA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
250 views4 pages

NT Bosch Edc17c19 Irom TC1792 Opel 1033

The document provides instructions for connecting to the ECU of an Opel vehicle. It specifies using cable CABLE F32GN037C and ensuring the power LED on the device is on. For DIMA connection an F34DM011 adapter is required, with the boot pin connected to pad 10 and boot switch in the on position. Alternatively the boot wire can connect directly to the orange boot clamp on the adapter.

Uploaded by

MOFIDE JAWDA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

BOSCH_EDC17C19_IROM_TC1792_OPEL VER 02.

02

PLUGIN 153

Dimsport srl – 15020 Serralunga di Crea (AL) - Italy- Tel. +39 0142 955 201 – WEB : www.dimsport.com -1-
BOSCH_EDC17C19_IROM_TC1792_OPEL VER 02.02

ECU CONNECTOR
In order to connect to the ECU use the CABLE F32GN037C.
Make sure that the POWER led (red) on NEW TRASDATA is ON.
Do not use this connection with the KIT DIMA.

Dimsport srl – 15020 Serralunga di Crea (AL) - Italy- Tel. +39 0142 955 201 – WEB : www.dimsport.com -2-
BOSCH_EDC17C19_IROM_TC1792_OPEL VER 02.02

BOOT DIRECT CONNECTION


Connect the GREY wire of the cable F32GN037C as described here below:

Dimsport srl – 15020 Serralunga di Crea (AL) - Italy- Tel. +39 0142 955 201 – WEB : www.dimsport.com -3-
BOSCH_EDC17C19_IROM_TC1792_OPEL VER 02.02

DIMA CONNECTION
For the DIMA connection is required the F34DM011 DIMA adapter.
Connect the boot pin to the pad n.10 of the soldering lay-by pins then verify that the switch BOOT
present on the F34DM011 is set in position ON.

A different solution is to connect the BOOT wire directly to the orange BOOT clamp on the DIMA
adapter F34DM011. Check that the yellow BOOT jumper is set in ON position.
Connect the DIMA flat cable to the New Trasdata.
The following picture of the DIMA adapter F34DM011 connection is merely indicative.

Dimsport srl – 15020 Serralunga di Crea (AL) - Italy- Tel. +39 0142 955 201 – WEB : www.dimsport.com -4-

You might also like