Scribd
Upload
163 views22 pages

PE-V0-415-158-A084 - Civil Design For Thickener & Thickened Sludge Sump-Cat1 PDF

The document derives a formula for calculating the thickness of concrete required to withstand a bending moment. It provides properties of concrete like permissible stress values. It then calculates the modular ratio, effective depth ratio, and percentage of steel reinforcement. Using these values and equations from the Tor steel handbook, it determines the depth of the neutral axis. Finally, it presents the key formula that calculates the required thickness (D) as 169 * square root of the bending moment (M) in tonne-meters.

Uploaded by

Ankita Pal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
163 views22 pages

PE-V0-415-158-A084 - Civil Design For Thickener & Thickened Sludge Sump-Cat1 PDF

The document derives a formula for calculating the thickness of concrete required to withstand a bending moment. It provides properties of concrete like permissible stress values. It then calculates the modular ratio, effective depth ratio, and percentage of steel reinforcement. Using these values and equations from the Tor steel handbook, it determines the depth of the neutral axis. Finally, it presents the key formula that calculates the required thickness (D) as 169 * square root of the bending moment (M) in tonne-meters.

Uploaded by

Ankita Pal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

CWL Doc No.

19-04/D-135-1

ANNEXURE-I

Derivartion of Formula for Thickness Calculation

Properties of Concrete:

Permissible stress for Direct Tension,ft = 1.5 N/mm2 Refer Table-1 & 2 of
Tension due to Bending, fct = 2.0 N/mm2 IS:3370-2009, Part 2

Permissible stress for Compression due to 10.0 N/mm2


Bending, fcbc =

2
modular ratio, m = 280/(3*fcbc) = 9.33 mm /N

Effectrive Depth/ Depth (d1/d) = 0.85


Percentage of Steel (p) = 0.282 % (Ref Tab 2.5, Tor Steel Handbook)

Depth of Neutral Axix (n) as per Tor steel Handbook

n= (1+0.00282*0.85*(9.33-1)/ (2+2*0.00282*(9.33-1)

n= 0.51

M/ bd2 =
2
(20/(1-0.51) * (1/3-0.51*(1-0.51)+(0.85-0.51) * (9.33-1) * 0.00282

= 3.502

5
D (reqd) = sqrt (M * 10 /3.502)

= 169 * sqrt (M) Where M is in T-m

You might also like