Section 1-222 Service PERFORMANCE CHARACTERISTICS INTRODUCTION Performance characteristics given in the Electical ‘Specitications apply when the instrument has been self calibrated within +5°C of the ambient temperature, has warmed up at least 20 minutes, and is operating in an ambient temperature between -10°C and +85°C (unless cthenvise noted. Environmental and Mechanical Specitications are listed after he Electrical Spectications, RECOMMENDED PERFORMANCE CHECK SCHEDULE To ensure accurate measurements, check the perform ‘ance of this instument every 2000 hours of operation (once each year used infrequently). repairs aremade, affected circuits may need to be readjusted, ELECTRICAL SPECIFICATIONS VERTICAL DEFLECTION SYSTEM Deflection Factor ‘5 mV per division to 50 V per dluision in a 1-2-5 sequence.! Vertical Resolution B8-bits, 25 levels per division. 10.24 dlvisions of dynamic range.* DC Accuracy ++15°C 10 +36 £9%2 “18°C 10 + 15°C #4%2 +85°C to +55°C £4962 {Pertormance Requirement not chacked in man imnan tho self ealloraon has been done witn =5°C ofthe ‘tmblon temperature. VOLTS/DIV Variable Control Increases the dotlection factor by 2.610 1. Aberrations +69, -6%, 6% p-p or ess.! ‘Measured with a 5-dlvision reference signal trom a 50-2 source driving a 60-0 load at the probe tip. Vertically center the top of the reference signal Useful Rise Time SECIDVX1.6 ! ae time is limited to 35 ns by the vertical amplifier responce, Useful Bandwidth a tet SAMPLE SECON Useful-storage bandwidth is limited to the ‘frequency where there are 10 samples per sine— ‘wave signal period at the maximum sampling rate. ‘This yields a maximum amplitude error of 59%, Max- ‘mum sampling rate is 10 Miz at § us per division, ‘Accuracy at the useful-storage-bandwidth limit is ‘measured with respect to a 6-dvision, 50-KHiz sine. wave. REPETITIVE 0.5 ys/dv to 50 us/dlv 10 Miz. 1 nsvalv 5 MHz.1 2usiaiv 25 MHz.4 Repetitive bandwith is limited to 10 MHz by the ‘analog system, 11Performance Characteristlcs~222 Service PEAK DETECT (ENV and CONT ENV acquieton ‘modes at 20 us per division and slower) Sine-wave Amplitude Capture (6% p-p maximum amplitude uncertainty) 1 Mee, Pulse Wicth Amplitude Capture (60% p-p maximum amplitude Uncertainty) 100 ns. A/D Converter Linearity Monotonic with no missing codes. Po: 1n Control Range ‘£12 divisions, Input Linear Range ‘£20 visions. DC Balance 0.2 division oF ess traco shift when switching between VOLTS/DIV switch sotings when te ambient temperature is within +5°C of the tem- perature at which the last self calibration was done. INVERT Balance 04 division oF less trace shift when switching between INVEAT and non-INVERT displays when the ambient temperature is within ++5°C of the tem- erature at which the last self calibration was done, Input Current 2.5 nA or less (0.5 division or less trace shit when ‘Switching batween DC and GND input coupling with the VOLTS/DIV switch at 5 mv per clvisior).4 Input R and © Input Resistance 1 Mo #10%.1 Inout Capacitance 27 pF +3 pF! ‘Those R and C characteristics include the probe ‘Common-to-Ground Capacitance Less than 150 pF ZX. ttaxinum Rated Normal-Mode Input Voltage (probe tip to probe common) 400. (dc + peak ac) to 2 MHz.t ‘See Figure 1-1 for voltage versus frequency erating curve. AX ttaxienum Common-Mode Potential (probe common to chassis) 400V (dc + peak ac) t kit ‘See Figure 1-2 for voltage versus frequency erating curve. LX. aximum Rated Potentiat Between Channels 800 V (de + peak ac).t 83 VOLTAGE (OC+PEAK AC) 100 ee 1 ie FREQUENCY 2m Towne Figure 1-1. Maximum normal-mode voltage versus frequency éerating curve. 12Performance Characteristics~222 Service VOLTS PEAK TO PEAK 8 00 ae rs 100 we FREQUENCY Figure 1-2. Maximum common-mode voltage versus frequency derating curve, ‘Common-Mode Rejection Ratio De-to-1 kHz 180 4 oF more. 1 kHtz-to-100 kHz {60.48 or more.t Isolation: Channel Signal to Channel Signal De-to-10 MHz 80.48 or more.4 Isolation: Channel Common to Channel Signal DO-to-1 kHz 1 kHz-to-100 kHz 180 48 or more. {60.48 or more. TRIGGER SYSTEM Internal Sensitivity 0.5 division to 20 MHz Level £20 divisions." External Sonstivity 250 mV at 10 Miz Level #23\. Input Resistance Ma £10%.1 Input Capacitance 18pF +5 pt ‘Performance Requirement not checked in mantal, ‘Trigger Jitter 2 usjatv to 50 nsjaiv (5 ns/div in X10 MAG). x 150th division ++2.ns.1 X10 MAG 1/8tn division +2 ns, HORIZONTAL SYSTEM Range 150 ns per division to 20 s per divsion.t “The X10 MAG control extends the maximum sweep speed to 5 ns per dhsion. Displayed Accuracy x 22%. x10 MAG. #5%.1 ‘Accuracy is over 10 divisions. ‘Sample Rate filles: tp NORMAL, SEC/DIV PEAKDET (ENV and, CONT ENV) 10.MHz. REPETITIVE SO nsidiv to 1 usidiv 10 MHz." 2 nsiain MHz." ‘ACCURACY 0.01%6.1 Sample accuracy is based on the accuracy of the 20-MlHz oscillator, 1-3Performance Characteristics~222 Service Record Length 12 data points; calibrated 10 $0 points per division.4 POSITION Control Range ‘Start ofthe first aivision and endo the tenth division ‘can be positioned past the center vertical graticule. Displayed Trace Length 10.28 divisions." XY OPERATION ‘Accuracy ‘Same as the Vertical system. Useful Bandwidth soon ‘Skew Between CH 1 and CH 2 Snst RS-232 INTERFACE Maximum Applied Voltage (any pin) 25V (do + peak ac). Baud Rates 300, 1200, 2400, 9600; 0.1% accuracy based on the microprocessor clock! Signals RD, TD, and SGND. SGND is connected intemally 0 EXTERNAL TRIG COM. DSR and CTS are always high, and BTA and RTS are ignored. Levels Compatiole with RS-2320. ‘Performance Requirement not checked in manual. 14 EXTERNAL POWER REQUIREMENTS Voltage Range Pin-to-pin ac 18.0 to 20 Vac at 47 to 400 H2. po 12t0 28 Vde.4 thor Power Pin-to- xT TRIG COMM or AS-232 comm -05V10 28 Vac peak. Current 1 ampere maximum when charging batteries. Naximum Power Consumption 15 watts or 18 volt-amperes (when charging batterios).! Internal Batteries Batiory Sealed, lead-acid battory.1 Charge Time Trree hours for ful charge with oscilloscope not cperating.! Battery Excessive Discharge Protection Instrument operation is automatically intemupted when battery charge drops to 7.22 V1 ‘Wpical Operating Time ‘Two hours at maximum sample rate, no trigger, and AUTO TIMEOUT feature tuned off 1 Battery Capacity versus Temperature asec | 2°cww'c | ss 80% 100% 110%Performance Characteristies~222 Service ENVIRONMENTAL SPECIFICATIONS connector housing with the housing grounded {Site cab ciel on ne RET zSE erect Environmental Requirements: Vibration (operating) Iekurent wil meet te rogues. ‘Tektronix Standard 062-2853-00, Class 3. {Sminutes along each of 3 op fplacorantaf0G25 nanp-p Gg SSH Re ener ects, al he flowing wah fequery ved fom10 to 89 He i-¥-280000 egies fo: pe, Ci ‘ute avec, Hoo riutos at 8 qulpment, except jin each of the three major axes. All major feeenercee must bo above Sse Temperature opeaiig orb Feb Shock (Operating and Nonoperating) ial oA! Geshe #18t°h 100 g, hat-sine, 1-ms duration, 3 shocks per Nonoperating -81°C to +71°C axis each direction, fora total of 18 shocks.1 (60°F to + 160°F).1 ‘ested to MIL-T-28800D, para 4.55.13 and MECHANICAL SPECIFICATIONS 4.5.5.1.4 except that inpara 4.5.5.1.3, stops 4 and are performed before step 2(-51°C nonoperating Wein test). Equipment shall remain off upon retun to Welght ‘oom-ambienttemperature during stop 6. Excessive i oreesanigl ‘condensation shall be removed before operating Uislepbsieade gel cung sop 7? ‘with accessories tbs. Domestic Shipping Weight 7Ibs. Altitude Dimensions Operating 4,570 meters (15,000 foe. Length 8.91n 521mm. Maximum operating i in temperature docreases a oer 10 por 1000 oat 6.25 in (188.8 mm). ‘above 5,000 feet! : Nonoperating To 15,240 meters Cooling {60,000 tee!) ‘There are no cooling vents provided. Humidity (Operating and Nonoperating) Finish Five cycles. (120 hous) referenced to Tektronix Blue pebble finish with black synthetic MIL-7-288000 para 4.5.5.1.2tor type Il, Class tubber hand ores and black vinyl probe peach: 3 instruments. Operating and nonoperating at 25% (-536, +0%) relative humitly. Operating at +80°C and +55°C for all modes of Construction ‘peration: nonoperating at +30°C and Plastic cabinet. Gless-leminate circuit boars with +60°C. surtace-mountad components EM crt Moots radiated and conducted emission » CCRT graticule reais 8divisionshighby todhisions ot urea oe wide. The divisions are 0.5 cm on a side and the sub-part J, Class A. diagonal size Is 6.4 cm (approximately 2.5 inches). Tomeet EM! regulations and specifications, use A special low-reflectanco sutace on the ct face the spectied shielded cable and metal aid viewing inhigh-ambient ignt areas, "Perfomance Requirement not checked in mands, 18