Scribd
Upload
147 views

How To Use Secure CRT Print Serial Information

This document provides steps to print and save serial information from a camera using Secure CRT: 1) Open SSH on the camera website and Secure CRT, setting the port and baud rate. 2) Click "Raw Log Session" in Secure CRT to save the file in a custom path. 3) Input commands to get condition codes if the shell is protected. 4) Copy the device key, get a security key from Hikvision, and paste it into Secure CRT. 5) Reproduce issues and Secure CRT will capture information to send for analysis.

Uploaded by

Ionut Lapuste
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
147 views

How To Use Secure CRT Print Serial Information

This document provides steps to print and save serial information from a camera using Secure CRT: 1) Open SSH on the camera website and Secure CRT, setting the port and baud rate. 2) Click "Raw Log Session" in Secure CRT to save the file in a custom path. 3) Input commands to get condition codes if the shell is protected. 4) Copy the device key, get a security key from Hikvision, and paste it into Secure CRT. 5) Reproduce issues and Secure CRT will capture information to send for analysis.

Uploaded by

Ionut Lapuste
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

一 How to print serial information

【Tool】
Secure CRT，use to print and save serial information

【Step】
1. Open SSH of camera via the web page of the camera

2. Open secure CRT.

3. Open SecureCRT and set parameters as below (Note: Port should be set as the serial port
which you use. Baud rate should be set as 115200. The Parity should be set as None)
After connect：

4. Click Menu->File->Raw Log Session，then save the file in a custom path.


5. If Protect Shell is psh mode, please input “zhimakaimen” or “setDebug”to get condition code
of the device.

6. Copy Device Key, and send the device key to Hikvision technicans and they will provide you a
security key.
7. Pasting security code to become built-in shell(ash) pattern.

8. Click Enter key and then input setDbgCtrl 0xff 0x02 0x400 0x02
It will go to the following similar interface that means it is ok.
9. Reproduce the problem and then the secureCRT will capture the information.
10. Save the information and then send to us for analysis.

You might also like