2 3 6

Indoor IR IP Dome TWDR Camera

H3W2GR1, H3W2GR2, H3W4GR1 ø8mm

Installation Guide Pan

Rotation
© 2016 Honeywell International Inc. All rights reserved.
Document 800-21792 Rev. A T
W

W=

Tilt T =

7
x5 x5
0

M5 4

Indoor IR IP Dome TWDR Camera

H3W2GR1, H3W2GR2, H3W4GR1
or
Installation Guide

© 2016 Honeywell International Inc. All rights reserved.

Document 800-21792 Rev. A

1
PoE
7
2

ø8mm ø100mm/4”
7

Micro SD

1
2
5
LDR

T
W
1
W = PAL
T = NTSC
20s

4-1
 4 7

1 2

2
7
ø100mm/4”

x3
ø100mm ø120mm
LDR

3
T
W

W = PAL
T = NTSC 20s

PoE
6
Pan

Rotation
T
W

Micro SD W= Tilt

T =
4-2
 4 6

1 W
T
PoE
W = PAL
2 T = NTSC
20s

1
7

Micro SD Pan
2 T Rotation
W

ø100mm/4”
Tilt
5 W=

T =
ø100mm ø120mm

3
LDR
1

2
x3

4-3
 Important Safeguards
6 • Read and keep these instructions.
• Please ensure that your installation area can safely support the weight of the camera.
• Do not aim the camera toward an extreme light source to prevent damage to the CCD.
**** • This camera is rated for indoor operation. Do not expose this camera to rain or moisture.
• Do not touch the camera lens.
• Do not drop the camera or subject it to physical shock.
1 **** • Do not use a strong or abrasive detergent when cleaning the camera.
• Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments
(where the operating temperature is outside the recommended range of -22° F to
122°F [-30°C to 50°C]).

Regulatory Statements
FCC Statement of Compliance
2 Information to the User: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
H4W2GR1 harmful interference to radio communications. Operation of this equipment in a residential area
1 is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Note Changes or modifications not expressly approved by the party responsible for
3
compliance could void the user's authority to operate the equipment.

3 H4W2GR1 001F55241124 192.168.1.188

H4W2GR1- 001F55241124
This Class A digital apparatus complies with Canadian ICES-003.

Manufacturer's Declaration of Conformance

The manufacturer declares that the equipment supplied with this guide is compliant
with the European Parliament and Council Directive on the Restrictions of the use of certain
2
hazardous substances in electrical and electronic equipment (2011/65/EU), General Product
Safety Directive (2001/95/EC), and the essential requirements of the EMC
Directive (2014/30/EU), conforming to the requirements of standards EN 55022 for
1x emissions, EN 50130-4 for immunity, and EN 60950-1 for electrical equipment safety.

Waste Electrical and Electronic Equipment (WEEE)

Correct Disposal of this Product (applicable in the European Union and other
Cautions and Warnings
4 H4W2GR1 001F55241124 192.168.1.188
European countries with separate collection systems).

This product should be disposed of, at the end of its useful life, as per applicable
H4W2GR1- 001F55241124
local laws, regulations, and procedures.
THIS SYMBOL INDICATES THAT
DANGEROUS VOLTAGE
CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.

CAUTION: TO REDUCE THE RISK OF THIS SYMBOL INDICATES THAT

ELECTRIC SHOCK, DO NOT REMOVE COVER IMPORTANT OPERATING AND
(OR BACK). MAINTENANCE INSTRUCTIONS
NO USER SERVICEABLE PARTS INSIDE. ACCOMPANY THIS UNIT.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.

5
admin WARNING To ensure compliance with electrical safety standards,
CSA Certified/UL Listed LPS or Class 2 power adapters are required. Power
over Ethernet (PoE) shall be provided by listed Information
1234 Technology Equipment meeting the IEEE 802.3af PoE standard. The
PoE is not intended to be connected to exposed (outside plant)
networks.

www.honeywell.com/security
WARNING To comply with EN50130-4 requirements, a UPS should be
+1 800 323 4576 (North America only)
employed when powering the camera from 24 V AC.
https://www.honeywellsystems.com/ss/techsupp/index.html

CAUTION Invisible LED radiation (850 nm). Avoid exposure to beam. Document 800-21792 Rev. A

CAUTION This is a Class A product. In a domestic environment this product

may cause radio interference in which case the user may be required to
take adequate measures.
4-4