Scribd
Upload
816 views1 page

Container Reefer Operating Instructions - Thermoking mp-3000

The Thermoking MP-3000 unit automatically defrosts and can be programmed to maintain different temperature setpoints. To change the setpoint, press the setpoint button until the temperature setpoint icon flashes, enter the new setpoint using number keys, and press and hold the F4 button to save it. The unit may display alarm codes for faults; contact dispatch immediately in this situation and file a defect report upon returning to the yard.

Uploaded by

Habib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
816 views1 page

Container Reefer Operating Instructions - Thermoking mp-3000

The Thermoking MP-3000 unit automatically defrosts and can be programmed to maintain different temperature setpoints. To change the setpoint, press the setpoint button until the temperature setpoint icon flashes, enter the new setpoint using number keys, and press and hold the F4 button to save it. The unit may display alarm codes for faults; contact dispatch immediately in this situation and file a defect report upon returning to the yard.

Uploaded by

Habib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Thermoking Mp-3000

Defrosting

The Unit is programmed to automatically defrost. You are not required to do anything.

Programming Temperature

If nothing is displayed on the screen make sure genset is running, main circuit breaker
is up in the on position, there is good plug connection and switch on unit is in the on
position. Press the setpoint button. When TEMP. SETP. is displayed press the F4
button. The icon will begin to flash and the current setpoint will disappear. Enter the
new setpoint using the number keys. If the number is in the negatives use the +/- EXIT
button before using the number keys. Press and hold the F4 button, the icon will stop
flashing and the new setpoint will be displayed. Press the ESC (F1) button to verify
new setpoint.

Alarm Codes

If the unit is malfunctioning or displaying any fault codes contact dispatch


immediately. Write up a defect report for any alarm or fault codes when you return to
the yard.

You might also like