Scribd
Upload
727 views1 page

Measurement Hardness and Roughness of Crankshaft Pin

This document provides information on measuring the hardness and surface roughness of crankshaft pins for L(V)32/40 engines. It lists the maximum hardness limits of 240HB for L32/40 engines and 360HB for V32/40 engines. The maximum allowable surface roughness is Ra 0.4, with a target of Ra 0.1. Measurement positions around the crankshaft pin are provided.

Uploaded by

Geraldo Gazeto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
727 views1 page

Measurement Hardness and Roughness of Crankshaft Pin

This document provides information on measuring the hardness and surface roughness of crankshaft pins for L(V)32/40 engines. It lists the maximum hardness limits of 240HB for L32/40 engines and 360HB for V32/40 engines. The maximum allowable surface roughness is Ra 0.4, with a target of Ra 0.1. Measurement positions around the crankshaft pin are provided.

Uploaded by

Geraldo Gazeto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Measurement Hardness and Roughness for Crankshaft Pin

Vessel/Plant Engine Type: L(V)32/40 Temp. in area of Measurement :

Engine Serial No.: Cyl. No. Running Hours:


℃ ℉
Measured By: Company: STX Service Americas Inspection Date:

1. Hardness(HBrinell) Limit Value for L(V)32/40 engines In-Service


 L32/40 Limit Value : Maximum 240HB
 V32/40 Limit Value: Maximum 360HB

2. Surface Roughness: Maximum Ra 0.4. A minimum of Ra 0.1 would


be a target

Hardness : Surface Roughness:


L32/40: Position A B C D E F G Position A B C D E F G
240HB TDC(0°) TDC(0°)
Max. Ra 0.4
90° 90°
Target Ra0.1
V32/40: 180° 180°
360HB 270° 270°
Note: Note:

Please Note: When hardness and Roughness readings higher than Maximum limit value are found, immediately contact your nearest STX Service Center of technical
representative

Measurement sheet(Version 1.0) 01 Nov. 2017

You might also like