Scribd
Upload
35 views1 page

WT03

1. The document provides methods for measuring bending dimensions of bars and rebar. 2. It lists 5 reference numbers that each correspond to a method of measuring the total length (L) of a bar based on its bending dimensions like the length (l), height (H), depth (A), width (E), and diameter (Ø). 3. The general notes at the bottom provide additional information on concrete grade, steel type, and clear cover requirements for reinforcement.

Uploaded by

erattakoya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views1 page

WT03

1. The document provides methods for measuring bending dimensions of bars and rebar. 2. It lists 5 reference numbers that each correspond to a method of measuring the total length (L) of a bar based on its bending dimensions like the length (l), height (H), depth (A), width (E), and diameter (Ø). 3. The general notes at the bottom provide additional information on concrete grade, steel type, and clear cover requirements for reinforcement.

Uploaded by

erattakoya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

B

METHOD OF MEASUREMENT OF APPROX TOTAL LENGTH OF MEASUREMENTS OF BENDING


REF.NO DIMENSIONS
BENDING DIMENSIONS BAR(L) MEASURED ALONG
CENTER LINE Project Commercial
Client BAREEQ SAJID
Date 12/08/2022 Drawn Favas
H H Designed AK Sheet No
Revision
1. L=l+2H ARCHITECT

l *ref sheet A

L=2(A+E)+4Ø

A
2. E STRUCTURAL CONSULTANT
*d=Dia of bar

L=2(A+E)+20Ø
3. Iringallur jctn, near Hilite mall

A
E
Shafeeq Arcade, door number 10
*Ø=Dia of bar www.catenoid.space
Mob: 09447760662

ALL DIMENSIONS ARE IN mm . U.N.O


GENERAL NOTES

1) DRAWING SHOULD BE UNDERSTOOD IN


CONJUNCTION WITH THE ARCHITECTURAL& MEP
DRAWINGS AND DISCREPANCY IF ANY SHOULD BE
L=4C+20Ø BROUGHT TO NOTICE.

A
4. 2) DRAWING SHALL NOT BE SCALED AND
ONLY WRITTEN DIMENSIONS,MEASUREMENTS
SHALL BE FOLLOWED.
C *Ø=Dia of bar
3) CONCRETE - M20 GRADE AND STEEL - Fe 500 TMT

D
BARS U.N.O.
4) ALL DETAILING REQUIREMENTS ARE AS PER
IS:456-2000
5) CLEAR COVER FOR REINFORCEMENT:
E FOOTING 50 mm
PILE CAP 50 mm
PLINTH BEAM 30 mm
If angle with horizontal BEAM 25 mm
COLUMN 30 mm
5.
Y

is 45° or less SLAB 15 mm


E ABBREVIATIONS
L=A+E U.N.O - UNLESS NOTED OTHERWISE
TYP. - TYPICAL
A Ø - BAR DIAMETER
C/C - CENTER TO CENTER
N.T.S - NOT TO SCALE
EQ. - EQUAL

You might also like