Scribd
Upload
129 views

Hygard Plug - Technical Data

Hygard Plug is a liquid compound that is mixed with cement to form quick-setting plugs that can seal high-pressure leaks. It contains chemicals that accelerate the setting and hardening of cement plugs so they will not be washed away. Hygard Plug can be used to instantly plug leaks in underground structures like wells, tanks, sewers, and tunnels. To use it, one part Hygard Plug is mixed with two parts cement and quickly applied into holes while still stiff to seal leaks up to 1.5 inches wide.

Uploaded by

Eric Abela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
129 views

Hygard Plug - Technical Data

Hygard Plug is a liquid compound that is mixed with cement to form quick-setting plugs that can seal high-pressure leaks. It contains chemicals that accelerate the setting and hardening of cement plugs so they will not be washed away. Hygard Plug can be used to instantly plug leaks in underground structures like wells, tanks, sewers, and tunnels. To use it, one part Hygard Plug is mixed with two parts cement and quickly applied into holes while still stiff to seal leaks up to 1.5 inches wide.

Uploaded by

Eric Abela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PRODUCT

HYGARD PLUG
Cement Plugs to Seal High-Pressure Leaks
PRODUCT DESCRIPTION

HYGARD PLUG is a low viscous liquid which is mixed with fresh cement to form quick-setting cement plugs that instantly hardens
even against water flowing under pressure. The compound contains reactive chemical salts which accelerate the setting and
hardening of cement plugs, which will not be washed out, or deteriorate under pressure.

USES & APPLICATIONS

HYGARD PLUG is used to instantly plug pressure leakage or burst in below grade constructions, such as lift wells, tanks, sewers,
cisterns, cofferdams, tunnels, mines, etc., anchoring rock bolts in mining and tunneling operations.

INSTALLATION PROCEDURE

Add one part by volume of HYGARD PLUG to two (2) parts by volume of fresh portland cement. Mix quickly. As the mortar begins
to stiffen, scoop out by hand, ram into prepared hole, and hold firmly until hard set. Due to the rapid setting characteristics
of the material, only prepare a quantity of the mixture which can be placed within the prescribed set time of 20 seconds. It is
important to use only fresh, non-lumpy Portland cement.

Surface Preparation
Before mixing, V-cut the area around the leak to give a firm, clean hole of no less than 1”.

Application
Plug small leaks first. Holes up to 1-1/2” can be sealed with a single plug. Large holes should be reduced by building up the
sides and letting the mortar set before ramming in the final plug.

After running water has been stopped, the plugged areas should be plastered with mortar containing HYGARD PLUG to seal any
seepage or dampness.

PACKAGING

4 liter gallon container


www.rebtrade.com

MAIN OFFICE: Unit 2B Magara Townhomes. Sierra Madre cor. Esteban Sts. Mandaluyong City, Philippines TEL NOS.: 531.4654 to 55 FAX NO.: (632) 531.2768

You might also like