Scribd
Upload
96 views

SECTION 310-02 Acceleration Control

The document provides instructions for diagnosing and testing acceleration control and removing and installing the accelerator pedal on a 2008.50 Mondeo vehicle. It lists components to visually inspect for mechanical or electrical damage when diagnosing acceleration control issues. The removal procedure instructs technicians to remove the accelerator pedal by loosening its retaining bolt with a torque of 10 Nm. Installation is described as reversing the removal steps.

Uploaded by

Tiến Phát Công ty TNHH Đầu Tư Xây Dựng
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
96 views

SECTION 310-02 Acceleration Control

The document provides instructions for diagnosing and testing acceleration control and removing and installing the accelerator pedal on a 2008.50 Mondeo vehicle. It lists components to visually inspect for mechanical or electrical damage when diagnosing acceleration control issues. The removal procedure instructs technicians to remove the accelerator pedal by loosening its retaining bolt with a torque of 10 Nm. Installation is described as reversing the removal steps.

Uploaded by

Tiến Phát Công ty TNHH Đầu Tư Xây Dựng
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

310-02-1 Acceleration Control 310-02-1

SECTION 310-02 Acceleration Control


VEHICLE APPLICATION:2008.50 Mondeo
CONTENTS PAGE

DIAGNOSIS AND TESTING


Acceleration Control........................................................................................................... 310-02-2
Inspection and Verification.................................................................................................. 310-02-2

REMOVAL AND INSTALLATION


Accelerator Pedal............................................................................................................... 310-02-3
310-02-2 Acceleration Control 310-02-2
DIAGNOSIS AND TESTING

Acceleration Control
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of mechanical
or electrical damage.
Visual Inspection Chart
Mechanical Electrical
– Accelerator pedal – Wiring harness(s)
– Throttle body – Wiring harness
retaining clips
– Electrical
connector(s)
– Accelerator pedal
– Powertrain control
module (PCM)
– Electronic throttle
body

3. If an obvious cause for an observed or reported


concern is found, correct the cause (if possible)
before proceeding to the next step.
4. If the cause is not visually evident, verify the
symptom and refer to the diagnostic tab within
the Ford approved diagnostic tool.

2008.50 Mondeo 1/2009 G330245en


310-02-3 Acceleration Control 310-02-3
REMOVAL AND INSTALLATION

Accelerator Pedal

Removal
NOTE: Removal steps in this procedure may
contain installation details.
1. Torque: 10 Nm

E79479

Installation
1. To install, reverse the removal procedure

2008.50 Mondeo 1/2009 G885390en

You might also like