Scribd
Upload
153 views

414-02-Generator and Regulator 414-02

This document provides instructions for diagnosing, removing, and installing a generator and regulator on a 2008.50 Ford Mondeo with either a 2.0L or 2.3L Duratec-HE engine. The diagnostic section refers technicians to the general charging system information. Removal involves loosening accessory drive belt tension, disconnecting battery ground cable, and removing mounting bolts. Installation is the reverse of removal, taking care not to damage wiring harnesses and properly torquing all fasteners.

Uploaded by

Tiến Phát Công ty TNHH Đầu Tư Xây Dựng
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
153 views

414-02-Generator and Regulator 414-02

This document provides instructions for diagnosing, removing, and installing a generator and regulator on a 2008.50 Ford Mondeo with either a 2.0L or 2.3L Duratec-HE engine. The diagnostic section refers technicians to the general charging system information. Removal involves loosening accessory drive belt tension, disconnecting battery ground cable, and removing mounting bolts. Installation is the reverse of removal, taking care not to damage wiring harnesses and properly torquing all fasteners.

Uploaded by

Tiến Phát Công ty TNHH Đầu Tư Xây Dựng
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

414-02-1 Generator and Regulator 414-02-1

SECTION 414-02 Generator and Regulator


VEHICLE APPLICATION:2008.50 Mondeo
CONTENTS PAGE

DIAGNOSIS AND TESTING


Generator............................................................................................................................ 414-02-2

REMOVAL AND INSTALLATION


Generator — 2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4)............................................ 414-02-3
414-02-2 Generator and Regulator 414-02-2
DIAGNOSIS AND TESTING

Generator
1. REFER to Section 414-00 [Charging System -
General Information].

2008.50 Mondeo 1/2009 G328435en


414-02-3 Generator and Regulator 414-02-3
REMOVAL AND INSTALLATION

Generator — 2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4)

Removal

CAUTION: Make sure that the ignition key All vehicles


is removed. 3. Refer to: Accessory Drive Belt (303-05
NOTE: Removal steps in this procedure may Accessory Drive - 2.0L Duratec-HE (MI4)/2.3L
contain installation details. Duratec-HE (MI4), Removal and Installation).
4. CAUTION: Take extra care not to
Vehicles with 2.0L engine damage the wiring harnesses.
1. Torque: 15 Nm

E86476

Vehicles with 2.3L engine


2.

E70352

E87882

2008.50 Mondeo 1/2009 G954606en


414-02-4 Generator and Regulator 414-02-4
REMOVAL AND INSTALLATION
5. 1. Torque: 25 Nm
2. Torque: 47 Nm

E70353

6. NOTE: The following step is only required if a


stud is loosened when the nut is removed.
Torque: 47 Nm

x2

E73997

Installation
1. To install, reverse the removal procedure.

2008.50 Mondeo 1/2009 G954606en

You might also like