PT Semen Bosowa Maros

Baruga, Maros, SulSel, Indonesia

Plant Maros Cement Type II(MH) Date December 22, 2021

Production Period September 16, 2021 – November 15, 2021

STANDARD REQUIREMENTS
ASTM C150/C150M

CHEMICAL PHYSICAL
Spec. Test Spec. Test
Item Item
Limit Result Limit Result
SiO 2 (%) A 20.6 Air content of mortar (volume %) 12 max 8
Al 2O 3 (%) 6.0 max 4.4 Blaine fineness (m 2/kg) 260 min 377
Fe 2 O 3 (%) 6.0 max 3.3 430 max
CaO (%) A 62.9 Autoclave expansion (%) 0.80 max 0.04
MgO (%) 6.0 max 2.2 Compressive strength (MPa) min:
SO 3 (%) 3.0 max 3.2 1 day A
Ignition loss (%) 3.5 max 2.7 3 days 7.0 23.4
Na 2 O (%) A 0.19 7 days 12.0 29.8
K 2O (%) A 0.50 28 days A
Equivalent alkalies (%) A 0.52 Time of setting (minutes) (Vicat)
Insoluble residue (%) 1.5 max 0.27 Initial Not less than 45 124
CO 2 (%) A 1.2 Not more than 375
Limestone (%) 5.0 max 3.5 Heat of hydration (kJ/kg) (ASTM C1702)
CaCO 3 in limestone (%) 70 min 79 3 days B 245
Inorganic processing addition Test Method C1038/C1038M Mortar Bar D 0.010 E
(ground, granulated blastfurnace slag) 5.0 max 3.0 Expansion (%)
Potential phase composition (%) C
A
C 3S 59
C 2S A 10
C 3A 8 max 5
C 4AF A 10
C 4AF + 2(C 3 A) A 20
C 3S + 4.75(C 3 A) 100 max 83
A Not applicable.
B Test result represents most recent value and is provided for information only.
C Adjusted in accordance with A1.6.
D Required only if percent SO 3 exceeds the limit in Table 1, in which case the Test Method C1038/C1038M expansion shall not exceed 0.020 % at 14 days.
E Test result for this production period not available. Most recent test result provided.

OPTIONAL REQUIREMENTS
ASTM C150/C150M

CHEMICAL PHYSICAL
Spec. Test Spec. Test
Item Item
Limit Result Limit Result
Chloride (%) F 0.020 Early stiffening (%) 50 min 82
Compressive strength (MPa)
28 days G
28.0 min
F Limit not specified by purchaser. Test result provided for information only.
G Test result for this production period not yet available.

We certify that the above described cement, at the time of shipment, meets the chemical and
physical requirements of the ASTM C150/C150M – XX or (other) _______________ specification.

Signature: ________________________________________ Title: ________________________________________