100% RATED CAPACITY
STANDARD FEATURES: PRODUCT MAY NOT BE EXACTLY AS SHOWN
- REMOTE NEMA 4 (WATER RESISTANT) PUSH-BUTTON ON 12FT CORD FROM
POWER PACK.
- UL/CSA APPROVED.
- CHECKER DECK AND LIP.
- 42IN HIGH BOLT-ON GUARD RAILS WITH MID-RAIL 4IN KICK PLATE ON SIDES.
- HYDRAULIC (VELOCITY FUSE) FALL SAFE.
- BUILT-IN FLIP MAINTANCE STRUT.
- SAFETY STRIPING ON FOUR DECK SIDES.
- FACTORY PRE-SET LOWERING SPEED FOR SAFE LOWERING OF TABLE WITH
RATED LOAD.
- ANTI-SLIP POWDER COAT ON TOP SURFACES, DECK, AND LIP(S)
- POWDER COAT FINISH
DOCK SUMMARY:
MODEL: DL5-72X96-10
CAPACITY: 5000 LB
DECK SIZE: 72W X 96L
SUB-FRAME HEIGHT: 0 IN
LOWERED HEIGHT: 10 IN
TRAVEL: 59 IN
RAISED HEIGHT: 69 IN
LIFT TIME: 26 SEC
LIP WELD 60"W 18"L
ONE PIECE
LIP WELD 60"W 18"L
ONE PIECE
POWER PACK SUMMARY:
- POWERPACK, 5HP
- OPT,ED,UP TRAVEL NEMA 4X RATED LIMIT SWI
OPTIONS SUMMARY:
- SIDE B: BOLTED, DECK MOUNTED GUARD RAIL
- SIDE D: BOLTED, DECK MOUNTED GUARD RAIL
- SIDE A: DUAL PERSONNEL RESTRAINT CHAINS
- SIDE C: DUAL PERSONNEL RESTRAINT CHAINS
- 3/4-10 UNC NUTS MIN. TENSILE STRENGTH 60KSI
(Maximum Lifting Weight - 16000 lbs)
- KIT, ED, SHAFT W/PIN, CHAIN, 60in W LIP
- DECK, ED, TUBES, 60in W LIP
- OPT,ED,GUARD RAIL
- OPT,ED,CHAIN WITH HOOKS ALONG OPEN SIDES
- 440-480V /3PH /60HZ
- ANTI-SLIP POWDER COAT ON TOP SURFACES, DECK, AND LIP
- SHIP W/NUTS DECK MOUNTED 10inLH
- BLUE GIANT DECALS
FINISH:
- OPT,ED,FINISH,BLUE
CONTROLS:
- 24 VAC VOLTAGE CONTROL CIRCUIT THE LIP SHALL BE POSITIONED (ON OR ABOVE) TRUCK BED OR
- PUSH BUTTON STATION TWO BUTTON LANDING, AT A MINIMUM OVERLAP OF 4-6IN [102-152] GENERAL ARRANGEMENT
CUSTOMER APPROVAL FOR THE INFORMATION CONTAINED HEREIN IS THE CUSTOMER
SOLE PROPERTY OF BLUE GIANT EQUIPMENT SPSA
MANUFACTURING CORPORATION. ANY REPRODUCTION IN PART
OR AS A WHOLE WITHOUT THE WRITTEN JOB NAME
PERMISSION OF BLUE GIANT EQUIPMENT
NAME: CORPORATION IS PROHIBITED. SPSA
ARCHITECT/CONTRACTOR TITLE
UNLESS OTHERWISE SPECIFIED:
SIGNATURE:
DO NOT SCALE DRAWING PREPARED BY
DATE: DIMENSIONS ARE IN INCHES [mm}
B
JOB NUMBER SIZE DRAWING NO
TOLERANCES APPLY AS SHOWN BELOW
CB-594318-1-02
THIRD ANGLE PROJECTION
AFTER APPROVAL PLEASE FRACTIONAL ± 1/4 [6mm] DRAWN DATE
RETURN THIS DRAWING TO ANGLES ± 2° ConfigureBLUE
2023-03-06
BLUE GIANT DESIGN DATE SCALE APPROXIMATE WEIGHT
1:20 3735 lbs SHEET 1 OF 3
410 Admiral Blvd, Mississauga, Ontario, L5T 2N6 ■ 6350 Burnt Poplar Road, Greensboro, NC 27409 ■ (800) 872-2583 ■ Fax: 888-378-5781 ■ www.bluegiant.com ■ [email protected]
ALL APPROVAL DRAWINGS MUST BE SIGNED AND RETURNED TO PROCESS THE ORDER
10"
254
LOWERED
72"
1829
96"
2438
18" 18" 2" MAX.
457 457 50
2" MAX.
50 59"
1499 69"
TRAVEL 1753
RAISED
C
SECTION C-C
SCALE 0.0260943 : 1
GENERAL LAYOUT
B
SIZE DRAWING NO
CUSTOMER APPROVAL FOR MANUFACTURING
CB-594318-1-02
THIRD ANGLE PROJECTION
THE INFORMATION CONTAINED HEREIN IS THE
NAME: SOLE PROPERTY OF BLUE GIANT EQUIPMENT
SIGNATURE: CORPORATION. ANY REPRODUCTION IN PART
OR AS A WHOLE WITHOUT THE WRITTEN
DATE:
PERMISSION OF BLUE GIANT EQUIPMENT SCALE WEIGHT
AFTER APPROVAL PLEASE RETURN THIS DRAWING TO BLUE GIANT CORPORATION IS PROHIBITED. 1:42 3735 lbs SHEET 2 OF 3
410 Admiral Blvd, Mississauga, Ontario, L5T 2N6 ■ 6350 Burnt Poplar Road, Greensboro, NC 27409 ■ (800) 872-2583 ■ Fax: 888-378-5781 ■ www.bluegiant.com ■ [email protected]
ALL APPROVAL DRAWINGS MUST BE SIGNED AND RETURNED TO PROCESS THE ORDER
A A
102" 74"
2591 1880
B
B
10 1/2" SECTION B-B
SECTION A-A
267 DRAIN
SCALE 0.0319949 : 1 (IF REQUIRED) 4" SCALE 0.0319949 : 1
102
2"
51
NOTES:
1. CURB ANGLES TO BE USED: 3" x 3" x 1/4" [76mm x 76mm x 6mm] THICK 2"
2. CURB ANGLE ANCHORS SPACING TO BE 18" [457mm] MAXIMUM ON CENTERS 51 2 1/2"
3. PERIMETER OF PIT MUST BE KEPT LEVEL, PIT MUST BE KEPT SQUARE 64
(DIMENSIONAL TOLERANCE 1/4" [6mm]) 3" [76]
4. USE 3" [76mm] PIPE FOR HYDRAULIC AND 1" [25mm] PIPE FOR ELECTRICAL CONDUITS HYDRAULIC CONDUIT ELECTRICAL CONDUIT
(AVOID OVER BENDING POLY OR PLASTIC PIPE THAT WILL CAUSE KINKING)
5. MIN. SLAB THICKNESS: 6" [152mm]
6. MIN. CONCRETE STRENGTH: 3000 P.S.I
7. NOT APPROVED FOR CONSTRUCTION PIT DETAIL
B CB-594318-1-02
SIZE DRAWING NO
CUSTOMER APPROVAL FOR MANUFACTURING THE INFORMATION CONTAINED HEREIN IS THE THIRD ANGLE PROJECTION
NAME: SOLE PROPERTY OF BLUE GIANT EQUIPMENT
SIGNATURE: CORPORATION. ANY REPRODUCTION IN PART
OR AS A WHOLE WITHOUT THE WRITTEN
DATE:
PERMISSION OF BLUE GIANT EQUIPMENT SCALE WEIGHT
AFTER APPROVAL PLEASE RETURN THIS DRAWING TO BLUE GIANT CORPORATION IS PROHIBITED. 1:32 lbs SHEET 3 OF 3
410 Admiral Blvd, Mississauga, Ontario, L5T 2N6 ■ 6350 Burnt Poplar Road, Greensboro, NC 27409 ■ (800) 872-2583 ■ Fax: 888-378-5781 ■ www.bluegiant.com ■ [email protected]
