circuit, high transfer case motor circuit for short circuit to ground,

resistance short circuit to power, open circuit, high resistance

Transfer case Using the manufacturer approved diagnostic system,
control module clear the DTCs and retest. If the fault persists, install
internal failure a new transfer case control module and perform
routine - Transfer Case Replacement

P0903- Clutch Actuator Transfer case

00 Circuit - No sub motor circuit short NOTE: Transfer case motor resistance should be 0.2
type information circuit to ground, ohms to 10.0 ohms.
short circuit to
power, open Refer to the electrical circuit diagrams and check the
circuit, high transfer case motor circuit for short circuit to ground,
resistance short circuit to power, open circuit, high resistance
Transfer case Using the manufacturer approved diagnostic system,
control module clear the DTCs and retest. If the fault persists, install
internal failure a new transfer case control module and perform
routine - Transfer Case Replacement

P0915- Gear Shift Position Transfer case NOTES:

00 Circuit motor position
Range/Performance sensor circuit short
- No sub type circuit to ground, If additional transfer case circuit fault related DTCs are
information short circuit to also set, perform the relevant corrective action(s) first and
power, open retest.
circuit, high
resistance
Transfer case Transfer case motor position sensor voltage (sensor
selector fork supply to sensor ground) should be 8V to 11V, resistance
position sensor (signal A circuit to ground circuit) should be 16.0k ohms to
circuit short circuit 20.0k ohms and resistance (signal B circuit to ground circuit)
to ground, short should be 16.0k ohms to 20.0k ohms.
circuit to power,
open circuit, high
resistance
Transfer case selector fork position sensor voltage
Transfer case
(supply circuit to ground circuit) should be 4.0V to 6.0V.
selector fork
position sensor Refer to the electrical circuit diagrams and check the
failure transfer case motor position sensor circuit for short
Transfer case circuit to ground, short circuit to power, open circuit,
motor failure high resistance
Transfer case Refer to the electrical circuit diagrams and check the
control module transfer case selector fork position sensor circuit for
internal failure short circuit to ground, short circuit to power, open
circuit, high resistance
Using the manufacturer approved diagnostic system,
clear the DTCs and retest. If the fault persists, install
a new transfer case selector fork position sensor and
perform routine - Transfer Case Replacement
Using the manufacturer approved diagnostic system,
clear the DTCs and retest. If the fault persists, install
a new transfer case motor and perform routine -
Transfer Case Replacement
Using the manufacturer approved diagnostic system,
clear the DTCs and retest. If the fault persists, install
a new transfer case control module and perform
routine - Transfer Case Replacement

P0916- Gear Shift Position Transfer case

00 Circuit Low - No sub selector fork NOTE: Transfer case selector fork position sensor
type information position sensor voltage (supply circuit to ground circuit) should be 4.0V to
circuit short circuit 6.0V.
to ground
Transfer case Refer to the electrical circuit diagrams and check the
control module transfer case selector fork position sensor circuit for
internal failure short circuit to ground
Using the manufacturer approved diagnostic system,
clear the DTCs and retest. If the fault persists, install
a new transfer case control module and perform
routine - Transfer Case Replacement

P0917- Gear Shift Position Transfer case

00 Circuit High - No selector fork NOTE: Transfer case selector fork position sensor
sub type position sensor voltage (supply circuit to ground circuit) should be 4.0V to
information circuit short circuit 6.0V.
to power
Transfer case Refer to the electrical circuit diagrams and check the
control module transfer case selector fork position sensor circuit for
internal failure short circuit to power
Using the manufacturer approved diagnostic system,