Scribd
Upload
20 views1 page

Manual SIWAREX WP521 WP522 en - PDF Page 88

The document discusses scale parameters and functions for a DR 7 interface including trace recording cycle, trace storage method, and digital input filtering. Parameters like trace recording cycle and storage method can be configured via registers. Digital inputs can be assigned commands and an input filtering duration can be set.

Uploaded by

Cr Se
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views1 page

Manual SIWAREX WP521 WP522 en - PDF Page 88

The document discusses scale parameters and functions for a DR 7 interface including trace recording cycle, trace storage method, and digital input filtering. Parameters like trace recording cycle and storage method can be configured via registers. Digital inputs can be assigned commands and an input filtering duration can be set.

Uploaded by

Cr Se
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Scale parameters and functions

6.8 DR 7 interface parameters

Variable Note Type Length Read De- Min. Max. Modbus


(bytes) write fault Register
Trace record- Trace recording cycle. Every nth USHORT 2 rw 1 1 1000 1318
ing cycle measured value is recorded.
(Page 90) For example:
n=1: 10 ms
n=10: 100 ms

1 000: 10 s
Trace storage 0: Trace recording runs as circular BIT 0 rw 0 0 1 1319.16
method buffer
(Page 90) 1: Trace is stopped when trace
memory is full
Reserve 1 Reserve LONG 4 rw 0 0 - 1320
Reserve 2 Reserve FLOAT 4 rw 0 0 - 1322

6.8.2 Assignment for digital input 0, 1, 2


A command trigger can be assigned to a digital input. The assignment is made with the
command number: → Command lists (Page 133).
Assignment for input 0, 1, 2, 3:

Code Assignment
0 Not assigned
1…32767 Command triggered by a rising edge (0→1 transition)
32769…65535 (Command code + 32768): Command triggered by a falling edge (1→0 transi-
tion)

6.8.3 Input filtering (hardware setting)


To ensure that the inputs do not respond too quickly to the signal change, a minimum signal
pending time can be specified. The pending signal is not processed further until this time has
elapsed.
The following values can be set:

Value Duration of signal queuing Value Duration of signal queuing


0 No filtering 4 20 ms
1 5 ms 5 25 ms
2 10 ms 6 30 ms
3 15 ms 7 35 ms
8 40 ms

SIWAREX WP521/WP522
88 Manual, 04/2016, A5E36695225A

You might also like