Scribd
Upload
11 views

HW 3 Soln

This document contains the solutions to homework problems from an electrical engineering course. Problem 1 involves a non-uniformly doped semiconductor. The key points are that equilibrium conditions prevail, the electrostatic potential and electric field are related to the conduction band energy, and carrier concentrations and currents depend on position. Problem 2 gives the general recombination-generation equation. Problem 3 examines carrier diffusion and recombination in a silicon bar with excess carriers generated at the ends. Problem 4 considers quasi-Fermi levels and how they shift from equilibrium values under low and high level injection conditions due to changes in electron and hole concentrations.

Uploaded by

siddharth mohanty
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
11 views

HW 3 Soln

This document contains the solutions to homework problems from an electrical engineering course. Problem 1 involves a non-uniformly doped semiconductor. The key points are that equilibrium conditions prevail, the electrostatic potential and electric field are related to the conduction band energy, and carrier concentrations and currents depend on position. Problem 2 gives the general recombination-generation equation. Problem 3 examines carrier diffusion and recombination in a silicon bar with excess carriers generated at the ends. Problem 4 considers quasi-Fermi levels and how they shift from equilibrium values under low and high level injection conditions due to changes in electron and hole concentrations.

Uploaded by

siddharth mohanty
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

UNIVERSITY OF CALIFORNIA

College of Engineering
Department of Electrical Engineering and Computer Sciences
EE 130/230M Prof. King & Dr. Xu
Spring 2013
Solution to Homework Assignment #3

Problem 1: Non-Uniformly Doped Semiconductor


a) Equilibrium conditions do prevail because the Fermi level is invariant with position throughout the
semiconductor sample.
b) The electrostatic potential V = (Eref  Ec)/q where Eref is a constant reference energy level. Therefore, wherever Ec
slopes downward V slopes upward, and vice versa.
c) The electric field is related to the electrostatic potential: E = dV/dx = (1/q)dEc/dx. Therefore, the electric field
follows the derivative of the conduction band edge energy.
d) The carrier pictured is a hole in the valence band. Its potential energy (PE) corresponds to the position of the
valence band edge energy, and its kinetic energy (KE) corresponds to the difference between its energy and the
valence band edge energy. Remember that hole energy increases in the downward direction on an energy
band diagram.
e) The electron and hole concentrations depend exponentially on EF  Ei:
and
f) Since Jn,drift (x) = qμnn(x)E(x), the shape of Jn,drift (x) can be deduced from the product of E(x) sketched in part (c)
and n(x) sketched in part (e). Under equilibrium conditions, the total electron current density Jn = Jn,drift + Jn,diff =
0 so Jn,diff = Jn,drift. In words, Jn,diff varies in the opposite direction to Jn,drift.
Problem 2: Generation and Recombination of Carriers
The general Recombination-Generation equation is given by
Problem 3: Continuity Equation

(a) Excess carriers are generated at the two ends of the Si bar. Due to the concentration gradient, carriers diffuse
toward the center of the bar. Since pn > ni2 there will be net recombination wherever there are excess carriers,
so that the carrier concentrations will be reduced (exponentially) with increasing distance away from either
end of the Si bar. A qualitative sketch is shown below:

(b) Yes, low level injection conditions prevail inside the illuminated bar because the maximum value of
excess carrier concentration is 10-3ND which is much less than the equilibrium concentration of majority
carriers, i.e. n = n0 + n  n0
(c) The differential equation to be solved under steady state conditions with no light (GL = 0) inside the bar is

, where Dp is the diffusion coefficient.

(d) The general solution to this differential equation is


pn(x) =·e-(x/Lp) +·e(x/Lp), where is the diffusion length.
The boundary conditions are pn(0) = ND and pn(L) = ND
(e) Assuming that the electric field is small so that the hole drift current density is negligible compared to the
hole diffusion current density, i.e. Jp = Jp,diff:

Problem 4: Quasi-Fermi Levels


a) Equilibrium electron concentration is n0 = ND = 1015 cm-3 ; equilibrium hole concentration is p0 = ni2/n = 105 cm-3
(EF  Ei) = kT·ln(n/ni) = 5kT·ln(10) = 5×60 meV  EF is 0.30 eV above the intrinsic Fermi level.
b) so n = n0 + n  n0 (low level injection condition).
Since the electron concentration is not significantly affected, the electron quasi-Fermi level is not changed from
the equilibrium Fermi level, i.e. FN is located 0.30 eV above the intrinsic Fermi level.
The hole concentration is significantly affected (since p = p0 + p  p) so the hole quasi-Fermi level is shifted
significantly away from the equilibrium Fermi level:
Ei  FP = kT·ln(p/ni) = 2kT·ln(10) = 2×60 meV  FP is 0.12 eV below the intrinsic Fermi level.
c) so n = n0 + n  n and p = p0 + p  p (high level injection condition)
FN  Ei = kT·ln(n/ni) = 8kT·ln(10) = 8×60 meV  FN is 0.48 eV above the intrinsic Fermi level.
Ei  FP = kT·ln (p/ni) = 8kT·ln(10) = 8×60 meV  FP is 0.48 eV below the intrinsic Fermi level.

You might also like