Scribd
Upload
51 views

PIPESIM 2011 Training Course Labib Lect 4

This document provides instructions for using a single branch model in Schlumberger software to simulate gas well deliverability. It describes inserting a vertical well completion with tubing and analysis point, inputting reservoir and tubing data, running a pressure/temperature profile operation to calculate gas rate with outlet pressure of 800 psia, and viewing the resulting pressure-rate curve and temperatures on the plot.

Uploaded by

Mohammed Bahram
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
51 views

PIPESIM 2011 Training Course Labib Lect 4

This document provides instructions for using a single branch model in Schlumberger software to simulate gas well deliverability. It describes inserting a vertical well completion with tubing and analysis point, inputting reservoir and tubing data, running a pressure/temperature profile operation to calculate gas rate with outlet pressure of 800 psia, and viewing the resulting pressure-rate curve and temperatures on the plot.

Uploaded by

Mohammed Bahram
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

By: International Trainer

Dr.Eng. Labib Omar Hugari - Schlumberger Software Expert


1 Initials
Exercise 1: Calculating Gas Well Deliverability

In this exercise, you construct the simple physical


well model shown below and perform a simulation to
calculate deliverability.

1. Using the Single Branch toolbar, insert a vertical


completion, tubing, and NODAL analysis point, as
shown in the figure.
2. Edit the reservoir and tubing data according to the data
in the table.

2 Initials
Exercise 1: Calculating Gas Well Deliverability

3 Initials
Exercise 1: Calculating Gas Well Deliverability
• The vertical completion properties for Well_1 are shown in the figure
below.

4 Initials
Exercise 1: Calculating Gas Well Deliverability
• Click on the Calculate/Graph… button to see the
pressure “P” with gas rate “Q” curve.

5 Initials
Exercise 1:
Calculating Gas Well
Deliverability

• Double click on the


tubing to open the
tubing properties.
• Select the simple
model from the
Preferred Tubing
Model.

6 Initials
Exercise 1: Calculating Gas Well Deliverability

3. Select Operations > Pressure/Temperature Profile


Operation.
a) Select the Gas Rate as the calculated variable.
b) Specify an Outlet Pressure of 800 psia and click Run.
4. The flow rate displays below the plot. You can read the
bottomhole flowing pressure on the plot.
5. On the Plot menu, select Series.
6. Change the Y-axis to Temperature. You can read the bottom-
hole and wellhead temperatures on the plot.
7 Initials

You might also like