Scribd
Upload
18 views

Lab 4

Uploaded by

Aroob Shahid
Copyright
© © All Rights Reserved
Available Formats
Download as PDF or read online on Scribd
18 views

Lab 4

Uploaded by

Aroob Shahid
Copyright
© © All Rights Reserved
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
Experiment-4 Aim: Connect the computers in Local Area Network: Procedure: On the host computer On the host computer, follow these steps to share the Internet connection: 1. Log on to the host computer as Administrator or as Owner. 2. Click Start, and then click Control Panel. 3. Click Network and Internet Connections. 4. Click Network Connections. 5. Right-click the connection that you use to connect to the Internet, For example, if you connect to the Internet by using a modem, right-click the connection that you want under Dial-up / other network available. 6. Click Properties. 7. Click the Advanced tab. 8. Under Internet Connection Sharing, select the Allow other network users to connect through this computer's Internet connection check box, 9. If you are sharing a dial-up Intemet connection, select the Establish a dial-up connection whenever a computer on my network attempts to access the Internet check box if you ‘want to permit your computer to automatically connect to the Intemet. 10. Click OK. You receive the following message: ‘When Internet Connection Sharing is enabled, your LAN adapter will be set to use IP address 192.168.0. 1. Your computer may lose connectivity with other computers on your network. If these other computers have static IP addresses, itis a good idea to set them to obtain their IP addresses automatically. Are you sure you want to enable Internet Connection Sharing? 11. Click Yes. The connection to the Intemet is shared to other computers on the local area network (LAN). The network adapter that is connected to the LAN is configured with a static IP address of 192.1680. 1 and a subnet mask of 255.255.255.0 On the client computer To connect to the Internet by using the shared connection, you must confirm the LAN adapter IP configuration, and then configure the client computer. To confirm the LAN adapter IP configuration, follow these steps 1. Logon to the client computer as Administrator or as Owner. 2. Click Start, and then click Control Panel. 3. Click Network and Internet Connections. 4. Click Network Connections. 5. Right-click Local Area Connection and then click Properties. 6. Click the General tab, click Internet Protocol (TCP/IP) in the connection uses the following items list, and then click Properties. 7. Inthe Internet Protocol (TCP/IP) Properties dialog box, click Obtai automatically (if itis not already selected), and then click OK. an IP address Note: You can also assign a unique static IP address in the range of 192.168.0.2 to 254, For example, you can assign the following static IP address, subnet mask, and default gateway 8. IP Address 192,168.31.202 9. Subnet mask 255.255.255.0 10. Default gateway 192:168.31.1 11, In the Local Area Connection Properties dialog box, click OK. 12. Quit Control Panel

You might also like