R

9½” Satori WO24P-8

Ø 226.5±0.15

0.0
Ø 242.0 -0.5

Ø 209.3
Ø 120.0
Ø 5.3 (x9)
Ø 10.5 (x9) 116.4
9x40°
131.4

Specs :
FEATURES
Nominal Impedance 8Ω Free air resonance, Fs 24.5 Hz
Hard paper cone for improved piston operation (made in-house)
DC resistance, Re 5.8 Ω Sensitivity (2.83 V / 1 m) 88 dB
Large optimized motor system with under-cut pole piece and
Voice coil inductance, Le 0.56 mH Mechanical Q-factor, Qms 5.7
dual shorting rings
Vented aerodynamic cast aluminium chassis for optimum Effective piston area, Sd 255 cm 2
Electrical Q-factor, Qes 0.41
strength and low compression Voice coil diameter 49.5 mm Total Q-factor, Qts 0.38
Soft low damping rubber surround for optimum transient response Voice coil height 23 mm Moving mass incl.air, Mms 44.5 g
Linear symmetric suspension design for improved dynamic Air gap height 6 mm Force factor, Bl 9.9 Tm
performance Linear coil travel (p-p) 17 mm Equivalent volume, Vas 87.5 liters
Non-conducting fibre glass voice coil former for minimum damping Magnetic flux density 0.95 mm/N
1.1 T Compliance, Cms
Long life silver lead wires attached 180° apart for improved stability
Magnet weight 1.36 kg Mechanical loss, Rms 1.2 kg/s
Vented pole piece for reduced compression
Net weight 3.7 kg Rated power handling 90 W
High piston to chassis diameter ratio
* IEC 268-5, T/S parameters measured on drive units that are broken in.
Gasket and bolt hole protrusions for reduced coupling to speaker
cabinet

110 163

105 150

100 136

95 123

90 110

85 96
Ohm
dB

80 83

75 70

70 56

65 43

60 30

55 16

50 3
10 20 50 100 200 500 1k 2k 5k 10k 20 kHz
(IEC baffle, mic.distance 31.6 cm, SPL shown for 2.83 V / 1 m)

Response Curve : REV. 1 (06.01.2017)