Safety Rules and Documents for CHEM 1125, 1215, and 1225

Teaching Laboratories
Department of Chemistry and Biochemistry
Utah State University

Note: These safety rules and documents should be used for the purpose for
providing brief overview of safety requirements and should be treated as
supplemental to the Departmental Safety Policies
(https://chem.usu.edu/safety/SafetyNew-working).

Contents Page
I. Emergency Contact Information 2
II. Abbreviations for Categories of Chemicals 3
III. General Laboratory Safety Rules 4
IV. General Housekeeping Policy 6
V. General Policies for Glassware and Reagent Handling 7
VI. Procedures for Chemical Spills of Potentially Hazardous Materials. 8
VII. Procedures for Working in the Laboratory During the Covid-19 Epidemic 11
VIII. Documentation of Safety Training 12

1
I. Emergency Contact Information

(Revised on 25 May, 2019)

Campus Emergency........... 911

USU Safety Office ............. (435)797-2892
(Environmental Health and Safety Office, EH&S)

Robert Alumbaugh ........... (435)797-0115

2
II. Abbreviations and Symbols used for Categories of Chemicals:

(Revised on November 10, 2016)

Category Abbreviation Symbol

Biohazard B

Corrosive C

Dangerous D

Dangerous for environment DE

Explosive E

Flammable or Combustible F

Harmful H

Highly flammable HF

Highly toxic HT

Hygroscopic Hyg
Irritating I
Lchrymatory L

Oxidizing O

Reactive R

Toxic T

3
III. General Laboratory Safety Rules

(Revised on December 10, 2020)

1) Smoking is not allowed in University buildings or within 25 feet from the buildings.

2) Food or drink must not be stored in laboratory refrigerators or other areas of potential
biological or chemical hazard. Food containers should not be used as storage vessels for
laboratory materials. Food and drink consumption present possible routes for ingestion of
hazardous microorganisms or chemicals and is not allowed in laboratories.

3) Personal electronic devices are not allowed to be used in lab.

4) Contact lenses are not allowed for laboratory work.

5) Eye and face protection are important laboratory concerns.

a) Safety splash goggles must be worn in the lab at all times.
b) Special precautions should be considered when performing such activities as:
i) preparations of reagents (chemicals, acids).
ii) packaging of potentially hazardous reagents.
iii) handling, pouring, or mixing any caustic or corrosive materials.
iv) working with glassware under pressure or vacuum.

6) Clothing: It is required that standard laboratory coats be worn when working in the teaching
laboratories. Full-length pants with no holes, socks covering ankles, and shirts with sleeves
covering the shoulders that extend below the top of pants are also required. Natural fiber
clothing is recommended.

7) Shoes: Shoes must cover the entire foot. Sandals, clogs, pumps and other open-toed or
open-heeled shoes do not cover enough foot and are not allowed.

8) Gloves: Disposable gloves must be available when required. Appropriate gloves are to be
worn at all times when handling hazardous materials. No one type of glove is appropriate
for all types of chemicals. Glove compatibility should be checked prior to use. Glove
compatibility information is available from the glove manufacturer. Gloves should not be
worn in the hazardous environment and then worn to other areas such as offices or
hallways. The person wearing contaminated gloves could easily contaminate such items as
door knobs or computer keyboards where the normal users would not normally wear
gloves.

9) Hair should not be worn in a style such as would impair vision, cause distraction during job
functions or come in contact with work surfaces or moving equipment.

4
10) Hand washing is necessary before eating, drinking, smoking, before leaving the laboratory,
and after taking off gloves.

11) Pipetting by mouth is not allowed. Physical pipettors (bulbs, fillers, safety pipette,
controllers, etc) must be used.

12) Exits and aisles must not be obstructed by equipment, chairs, backpacks, books, supplies,
personal items or trash. Doors to the laboratory must be kept closed, exit doors must not be
blocked, locked, or obstructed in any way to inhibit exiting and entering the laboratory.

13) Hood Operation - All fume hoods are inspected annually. The EH&S office will place a
magnet with the inspection date and indicate whether the hood passed or failed inspection.
Always make sure the fume hood is operational before use. If any hood in your laboratory is
not functioning properly, contact LuAnn to initiate a work order through facilities.

14) Reporting of Accidents – All students are to immediately report any accident, no matter
how minor, to the teaching lab assistant or instructor.

15) Personal Conductivity - All students should be aware and cautious of other’s activities as
well as their own. Students are NEVER TO CONDUCT UNAUTHORIZED EXPERIMENTS. All
students are never to work alone in the lab. A teaching assistant (TA) must physically be
present in the lab and the pre-lab lecture must be complete before students may begin
preparation and working on an experiment. All students must follow safety precautions
given by the teaching assistant or instructor in the pre-lab lecture and during the lab.
Students missing the pre-lab lecture will not be allowed to begin the experiment.

16) Pregnancy – Students that are pregnant should obtain the list of all reagents that will be
used in the course available at the first lab check in meeting time. The student should meet
with their physician to determine whether or not to complete the lab course while they are
pregnant.

* You are required to know the locations of safety equipment, such as, spill absorbing kit, first-
aid kit, fire extinguisher, fire blanket, fire exits, eye-washer, and safety shower.

* Any violation will result in disciplinary action. The seriousness of the violation will be
determined by Mr. Robert Alumbaugh. The disciplinary actions may include, but are not limited
to, re-take of all the necessary training related to the infraction of the incident, suspension from
work, suspension of your enrollment in the course.

* Notices of violation will be reported and corrective actions and date completed will be filed
with Laboratory TA and copies will be sent to Mr. Alumbaugh.

5
IV. General Housekeeping Policy

(Revised on December 10, 2020 )

A. Laboratories must be kept clean and free of accumulations of trash or unused materials.

B. Reagents and equipment must be stored in an organized fashion and returned to their
designated locations, capped or cleaned, whenever they are not in active use.

C. Storage Areas: Make efficient usage of storage areas. Clean clutter including outdated
chemicals or chemicals which are not being used.

D. Chemical Storage: Check storage equipment for compatibility with chemicals to be stored.
Make sure all containers are labeled, including water containers. Do not store chemicals in
student lab drawers unless instructed by your TA.

E. Individual work surfaces must be cleaned by each student before and after each experiment.
Common work areas (balances, reagent shelves, and fume hoods) will be cleaned by
assignments made by the respective teaching assistant. Upon completion of the experiment
and cleaning of their work surfaces, all students are required to obtain their TA approval before
leaving the teaching laboratory.

F. Particular attention must be given to minimizing volumes of flammable liquids to minimal

quantities and storing laboratory chemicals according to compatibility and according to federal
regulations including the use of flammable solvent storage cabinets.

G. Hood Storage: If hoods are being used for storage of small equipment and containers,
identify the hood as such if used for storage only. Waste stored in hoods must be disposed of
on a regular basis.

6
V. General Policies for Glassware and Reagent Handling

(Revised on November 10, 2016 )

A. Glassware.

1. Inspect before using. Do not use broken or chipped glassware.

2. Do not attempt to remove stoppers on glass by excessive force.
3. Dispose of broken or discarded pieces in a specially marked separate container which
should be available in every lab.
4. Hot glass containers should be handled with heat resistant gloves.
5. Broken glassware should be picked up with a brush and pan - NOT with the fingers.

B. Safe Handling of Flammable Liquids.

1. Use flammables only in well-ventilated areas (hoods).

2. Do not permit any open flames in flammable-vapors area.
3. Do not use old, poorly maintained equipment which might generate sparks or
overheat.
4. Sufficiently isolate or otherwise control all ignition sources - ovens, electrical hot
plates, electric motors, etc.
5. Heating and drying of flammable liquids should be done in the appropriate hood.
6. Equipment used for heating flammables must be in good condition and have
automatic disconnects in the event of overheating.
7. Keep hot surfaces away from flammables.
8. Clean spills immediately, using proper procedures.
9. Maintain a minimum stock of flammables.
10. Personal protective equipment must be available for required uses.
11. Allow for rapid unencumbered exit when using flammables.
12. Flammable liquids that need to be kept at or below refrigerator temperatures, must
be stored only in explosion-safe refrigerators or freezers.
13. Flammables and oxidizers must be stored separately.
14. Know the location of the nearest fire extinguisher.
15. Do not work alone when using hazardous flammable liquids.
16. A teaching assistant must be present in the lab room before students are allowed to
work or prepare equipment and reagents.

7
VI. Procedures for Chemical Spills of Potentially Hazardous Materials

(Revised on December 10, 2020 )

Pre-incident

1. Determine classes or categories of chemicals based on spill response needs, i.e. acids, toxic,
irritant, flammable.

2. You must know the location of spill clean-up material in your laboratory.

3. Know how to contact emergency personnel for additional help.

Campus police (911)

EH&S (797-2892)
Robert Alumbaugh (797-0115)

4. Transfer reagents with care (Refer to the General Policies for Glassware and Reagent
Handling for more information). Always follow these policies:

(i). Always use a funnel.

(ii). Do not overfill the receiving bottle.
(iii). Use secondary containment as necessary.

Post-incident – Protect human health and safety

1. Immediate actions to be taken by all involved personnel

(i). Exit and isolate the affect area.

ii). Check for individual involvement for injury and chemical contamination.
(iii). If it is safe to do so, isolate the spill.
(iv). Contact emergency personnel if any personal contamination or injury.

2. Determine the level of risk. Check the flowchart on page 11 for quick reference.

(i) What chemical is involved?

(ii) How much is involved?
(iii) Where is the location of the spill?

For LOW RISK situations, follow step 3.

For HIGH RISK situation follow step 4.

8
3. Low risk spill

(i) Inform teaching assistant and/or Robert Alumbaugh of the spill.

(ii) Use proper protective equipment, such as proper gloves and spill-absorbing
material to clean up the area.
(iii) After the spill has been absorbed, place the absorbent in a container with a
properly fitting lid. Place the container in the hood. The respective teaching
assistant will arrange for the disposal with EH&S (797-2892).

4. High risk spill

(i) Inform the teaching assistant and/or Robert Alumbaugh of the spill.
(ii) The teaching assistant and/or Robert Alumbaugh will then perform the
following:
a. Activate Campus emergency response team by contacting the campus
police (911) and EH&S (797-2892).
b. If other local professional emergency response is necessary, call 911
and request support from fire department, city police, and
ambulance.
c. Remain available to provide information to the response team.

5. Ensure personal safety of response personnel.

6. Assist the emergency response team with the clean-up of material in a container with a tight
fitting lid. Place the container in the hood and arrange the disposal with EH&S (797-2892).

7. Request analysis and inspection of the spill area from EH&S (797-2892) and Facilities (797-
1947) for resumption of activity.

8. Re-stock the spill-absorbing material.

9
Spill Response Procedure Flowchart

Immediate Actions
clear affected area
check for individual
involvement
isolate the spill
contact emergency

Rick Assessment

Large spill Small spill

High hazard materials Low hazard materials
Difficult location Easy location

High Risk Low Risk

Activate emergency Use area workers or

response team and/or emergency response
request professional team as considered
emergency support appropriate

Clean-up procedure

Area inspection

Re-occupation of area

resumption of activity

10
VII. Procedures for Working in the Laboratory During the Covid-19 Epidemic
(Revised on 24 August, 20201)

1. USU is encouraging everyone to wear a mask in class.

2. A COVID vaccine is the most powerful tool we currently have against infection. If you
haven’t yet been vaccinated, I urge you to consider getting the vaccine.

3. If you are sick (even mild symptoms), don’t come to class. Let me know and I will make
sure you get to participate.

4. If you stay home sick, test positive for COVID or are exposed to someone who has
COVID, fill out the questionnaire on the top right of the page https://www.usu.edu/covid-
19/testing/index. (Links to an external site.) You will be sent instructions on what to
do.

5. If you think you have COVID, get tested. USU has free
testing: https://www.usu.edu/covid-19/testing/index (Links to an external site.)

11
VIII. Documentation of Safety Training

(Revised on 24 August, 2021)

1. All students are required to read the Safety Rules and Documents for CHEM 1125,
1215, and 1225, Teaching Laboratories

2. All students are required to follow the specific procedures developed for the
experiments.

3. Remove this page. Complete, sign, and date all training items of section VIII (both
front and back of this sheet). You may keep a copy of Section VIII as your record.
Upload a signed copy of Section VIII (this sheet) to Canvas. Failure to provide your TA
with this signed page may result in your being dropped from the course.

Check the space after you complete the specific training

Name: Marren Williams (print)

A02366265 CHEM 1215

A number: Course:

□ I have read and understand General Laboratory Safety Rules

9/5/21

Date

□ I have read and understand the General Housekeeping Policy

9/5/21

Date

12
□ I have read and understand the General Policies for Glassware and Reagent Handling

9/5/21
Date

□ I have read and understand Procedures for Chemical Spills of Potentially Hazardous Materials

9/5/21

Date

I hereby state that I have completed all required training. I understand and agree to abide by all
laboratory rules and regulations. I agree to accept all disciplinary actions for any violation of the
laboratory rules and regulations. I also accept full responsibility for any medical expenses or damage to
personal clothing resulting from participation in the teaching laboratory.

9/5/21

Signature Date

13