Scribd
Upload
33 views

Notes Power

Sinusoidal pulse width modulation (SPWM) compares a sinusoidal reference signal to a triangular carrier wave to generate gating signals that control the width of pulses proportionally to the sine wave amplitude. The output frequency is determined by the reference signal frequency, while the RMS output voltage is controlled by modulation index and peak amplitude. The voltage is calculated based on the switching states and input voltage. The number of pulses per half cycle depends on the carrier frequency. Pulse width modulation is commonly used to control the output voltage of inverters by adjusting the on and off periods of components to produce a controlled AC output from a fixed DC input. It reduces harmonic distortion in the load current by modulating the pulse width of a square wave

Uploaded by

vishalssawant66
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
33 views

Notes Power

Sinusoidal pulse width modulation (SPWM) compares a sinusoidal reference signal to a triangular carrier wave to generate gating signals that control the width of pulses proportionally to the sine wave amplitude. The output frequency is determined by the reference signal frequency, while the RMS output voltage is controlled by modulation index and peak amplitude. The voltage is calculated based on the switching states and input voltage. The number of pulses per half cycle depends on the carrier frequency. Pulse width modulation is commonly used to control the output voltage of inverters by adjusting the on and off periods of components to produce a controlled AC output from a fixed DC input. It reduces harmonic distortion in the load current by modulating the pulse width of a square wave

Uploaded by

vishalssawant66
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ROHINI COLLEGE OF ENGINEERING & TECHNOLOGY

4.6 PWM CONTROL: Sinusoidal pulse width modulation (SPWM)

In Sinusoidal Pulse Width Modulation triangular carrier signal is


compared with sine wave. Figure below explains the generation of a
sinusoidal PWM signal, which finds more applications in industries. The
gating signal can be generated by comparing a sinusoidal reference signal
with a triangular carrier wave and the width of each pulse varied
proportionally to the amplitude of a sine wave evaluated at the center of
the same pulse. The output frequency (fo) of the inverter can be found by
using the frequency of the reference signal (fr). The rms output voltage (vo)
can be controlled by modulation index M and in turn modulation index is
controlled by peak amplitude (Ar). The voltage can be calculated by VO =Vs
(S1- S4) . The number of pulses per half cycle depends on the carrier
frequency. The gating signal can be produced by using the unidirectional
triangular carrier wave.

Figure 4.6.1. Multiple pulse width modulation

[Source: “Power Electronics” by P.S.Bimbra, Khanna Publishers Page: 352]

EE 8552- POWER ELECTRONICS


ROHINI COLLEGE OF ENGINEERING & TECHNOLOGY

The frequency of control signal or the modulating signal sets the


inverter output frequency (fo) and the peak magnitude of control signal
controls the modulation index ma which in turn controls the rms output
voltage. The area of each pulse corresponds approximately to the area
under the sine wave between the adjacent midpoints of off periods on the
gating signals. If ton is the width of nth pulse, the rms output voltage can be
determined by:

Pulse width modulation is the most commonly used technique to


control the output voltage of inverter. In pulse Width Modulation method, a
fixed dc input voltage is given to the inverters and a controlled ac output
voltage is obtained by adjusting the on and off periods of the inverter
components.

PWM is a technique that is used to reduce the overall harmonic


distortion THD in a load current. It uses a pulse wave in square form that
results in a variable average waveform value, after its pulse width has been
modulated.

EE 8552- POWER ELECTRONICS

You might also like