Scribd
Upload
57 views

Chain Sling Checklist

This document is a lifting appliance checklist for a chain sling used at the Meerut RRTS UG Project site. It lists the capacity and serial number of the chain sling, as well as inspection criteria such as allowable abrasion, twisting, cracks, bending, or elongation. The checklist notes whether the safe working load is punched or marked, and whether inspections found issues like rust, safety latch condition, oblongs, wear and tear, or overall unsatisfactory condition. It is signed by the lifting supervisor after inspection.

Uploaded by

swarnajit paul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
57 views

Chain Sling Checklist

This document is a lifting appliance checklist for a chain sling used at the Meerut RRTS UG Project site. It lists the capacity and serial number of the chain sling, as well as inspection criteria such as allowable abrasion, twisting, cracks, bending, or elongation. The checklist notes whether the safe working load is punched or marked, and whether inspections found issues like rust, safety latch condition, oblongs, wear and tear, or overall unsatisfactory condition. It is signed by the lifting supervisor after inspection.

Uploaded by

swarnajit paul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

MEERUT RRTS UG PROJECT

LIFTING APPLIANCE CHECKLIST


Doc. No: AFC /4559/CPE/F/15

Site

Lifting gear Chain Sling Lifting Gear Serial Number

Capacity (SWL)

List of Lifting Gear Date of Examination/Inspection Due Date of Examination/Inspection

Chain Sling
Rejection Criteria of Chain Sling:

1.The amount of abrasion shall not be more than 10% of the link bar diameter or 10% of the assistive devices thickness.

2.If the chain is twisted by more than 10 degrees whilst loaded.

3.If cracks, bending or distortions are present and ring hinge got stuck or acerbity sluggish phenomenon which they cannot be ruled out.

4.If permanent elongation of the chain and / or a single link shall not exceed 5% of the original length.

Description:

1. Is SWL Punched or Marked? YES / NO

2. Is check for rusting of chain done? YES / NO

3. Is safety latch in good condition? YES / NO

4. Is oblongs in good Condition? YES / NO

5. Is check for wear and tear carried out? YES / NO

6. Is overall condition satisfactory? YES / NO

7. Others specify

8. Reason For Rejection

Checked by Lifting Supervisor

Name of Lifting Supervisor/Company

Date of Inspection

Signature

You might also like