Scribd
Upload
19 views

Cobra Alarm Fob Reprogramming

The document provides instructions for programming additional transmitter fobs for a car alarm system and what to do if disconnecting the car battery. It states that up to 4 fobs can be programmed to the system by simultaneously pressing the buttons on an existing fob for 10 seconds, then repeating with any other fobs and doing an ignition on/off sequence 3 times within 7 seconds. It then details entering the owner's PIN by counting security telltale flashes and turning the ignition on and off between each digit. The instructions warn to turn off the ignition for 10 seconds if a mistake is made entering the PIN. It also notes that before disconnecting the battery, the alarm system must be disarmed and mobilized.

Uploaded by

remoxef760
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
19 views

Cobra Alarm Fob Reprogramming

The document provides instructions for programming additional transmitter fobs for a car alarm system and what to do if disconnecting the car battery. It states that up to 4 fobs can be programmed to the system by simultaneously pressing the buttons on an existing fob for 10 seconds, then repeating with any other fobs and doing an ignition on/off sequence 3 times within 7 seconds. It then details entering the owner's PIN by counting security telltale flashes and turning the ignition on and off between each digit. The instructions warn to turn off the ignition for 10 seconds if a mistake is made entering the PIN. It also notes that before disconnecting the battery, the alarm system must be disarmed and mobilized.

Uploaded by

remoxef760
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

- Release both buttons; the fob tell tale should come on con-

Keys & Car Security Alarm


stantly.
- Press the larger button for one second (the fob tell tale will
flash). Synchronisation is complete.

Programming Additional Transmitter Fobs


Two transmitter fobs are provided with the new car. If one
transmitter is lost or damaged, a replacement should be ob-
tained immediately from your dealer, and programmed to the
car alarm controller using a functioning transmitter fob and the
system owner’s unique Personal Identification Number (PIN).
Up to 4 transmitter fobs can be matched with the alarm system,
but all fobs must collectively undergo the single programming
operation:
1. Press, simultaneously, both buttons on a transmitter fob
until the fob tell tale stops flashing (approx. 10 seconds).
On release of the buttons, the fob tell tale will light.
2. Repeat operation (1) for ALL the transmitter fobs required to
operate the system.
3. Turn the ignition on and off 3 times within 7 seconds; the
security tell tale in the tachometer will light for 3 seconds.
4. Enter the PIN: Immediately the tell tale goes out, switch ON
the ignition and count the number of security tell tale flashes
until equal to the first number of the PIN, then turn the ignition
OFF, then back ON again.
5. Repeat operation (4) for the remaining 3 digits of the PIN,
remembering to turn the ignition OFF and back ON after each
code number.
Note: If at any time a mistake is made when entering the
PIN, turn the ignition OFF for 10 seconds and re-commence
entering the PIN.
6. If the PIN is correct, the security tell tale will be lit. Test op-
eration of each transmitter fob.

Disconnecting the Car Battery


If the battery is to be disconnected, refer to the ‘Battery’
section later in this handbook which includes the following
precaution:
- Before disconnecting the battery, ensure that the alarm system
is disarmed and mobilised.

36

oh_croft_InD.indd 36 20/05/2004 07:58:48

You might also like