Scribd
Upload
118 views

Fabric Physical Quality Inspection Procedure SOP-V2

This document provides procedures for inspecting fabric physical quality. It outlines equipment needs like a yardage counter and flat viewing surface. It describes lighting requirements of at least 100 foot candles. The inspection process includes checking for shade consistency from side to side, end to end, and roll to roll. Defects are graded on a scale of 1 to 5, with 1 being much changed and 5 being negligible. Measurements of cuttable width and other metrics ensure quality standards are met. Spectral data from 31 points is also analyzed.

Uploaded by

nikhilmali308443
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
118 views

Fabric Physical Quality Inspection Procedure SOP-V2

This document provides procedures for inspecting fabric physical quality. It outlines equipment needs like a yardage counter and flat viewing surface. It describes lighting requirements of at least 100 foot candles. The inspection process includes checking for shade consistency from side to side, end to end, and roll to roll. Defects are graded on a scale of 1 to 5, with 1 being much changed and 5 being negligible. Measurements of cuttable width and other metrics ensure quality standards are met. Spectral data from 31 points is also analyzed.

Uploaded by

nikhilmali308443
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 35

Fabric Physical Quality

Inspection Procedure

1
CONTENT

2
3
4
5
Ensure fabrics meet quality requirements

6
7
8
9
10
11
12
13
•
•
•
•
•
•
•

14
15
Equipment Requirement
Yardage/meter
counter

Flat viewing
surface,
45 ~ 60 degree to Maximum inspection speed
the horizontal.
( 20 yards/min )

Clean, Neat and Safe


Tension free machine for knitted fabrics
16
Inspection Lighting

Overhead Daylight Fluorescent Lamp


Minimum 100 foot candle (1075 lux)
on the surface of the fabric.
Light Meter

17
18
19
20
21
• Check Side to Side Shade Check
• Check Side to Side/ Side to Center Shade Check
• Check End to End Shade Check
• Refer to adidas’ color manual
• Check Subsequent Lot’s Color Shade Check
• Check Roll to Roll Shade Check

22
GRADE EXPLANATION
• 5 NEGLIGIBLE OR NO CHANGE
• 4-5 General
• 4 SLIGHTLY CHANGED Acceptable
• 3-4 Level
• 3 NOTICEABLE CHANGED (Gray scale 4-5
or above)
• 2-3
• 2 CONSIDERABLE CHANGED
• 1-2
• 1 MUCH CHANGED

23
24
25
26
Cuttable Width:
needle holes to needle holes

27
28
29
•
•
•
•
•
•

30
•
•
•
•
•

31
32
33
34
31 points spectral data

35

You might also like